DECAL:
DY8968
Dynam RC
dynam-rc.cn
of
This product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Please recycle.
over
DIRECTIONS FOR ASSEMBLY AND ADJUSTMENT
Control Throw Setting Suggestion
Elevator Aileron Rudder
11.1V 2200mAh
Li-Po, 25C
(10x6)
ESC-40A
ESC-40A
Lithium-polymer Battery
2200mAh 11.1V
25C Discharge
Rechargeable Cells
Use li-po charger only
MOTOR
8
3 4 5 6
7 8
9
10
11
12
1
2 3
4
5
6
7
Glue the wing tips.
Apply glue to the Vertical stabilizer.
lnsert the pushrod into elevator quick-controller
and tighten the screw(the servo should be in
center position).
Install the propeller. Install spinner with PA2.5*8mm screws.
9
12
Secure elevator servo horn with PM2*14
mm screws.
Apply glue to the elevator and insert it
in the fuselage.
CENTER OF GRAVITY(C.G.)
45 50 45 50
17 18
15
14
11
16
12
9
3
5
7 8
10
4
6
LANDING GEAR ASSEMBLY:
ASSEMBLY:
Glue the pilots.
Cut the lines with knife to ensure
the position of nose wheel.
Cut the lines with knife to ensure
the position of rear wheel.
Install the nose wheel in the
fuselage as shown.
Glue the cover in position.
Install the PWM3*25mm screws
on the undercarriage.
Install rear wheels with M3 nuts,
then apply glue to the surface.
Secure the horn of nose wheel
with PM3*6mm screw.
Thread the landing gear under
the motor wires.
Fix the undercarriage with PM3*16mm
screws.
Glue the canopy.
Secure the water rudder with
PA2*6mm screws.
Glue the wing cover in place.
Secure the wing onto the fuselage
with PM3*35mm screws.
PM3*35mm
SWD-01 Fuselage
SWD-02 Main Wing
SWD-03
Elevator
SWD-04 Vertical Stabilizer
SWD-05 Wing tips SWD-06 Blister parts
SWD-08 Canopy
SWD-09 Push Rod
SWD-07
Cowl
SWD-14 Servo Horn SWD-15 Decal
DYB-10 Pilot
DY-1007 9g Servo
DYR-2001 2.4G Receiver
DYT-2001 4CH Transmitter
DYE-1004 40A ESC
DY-6015 11.1V 2200mAh
25C Battery
BM3715A-KV1050
Brushless Motor
BM3715A-KV1050-Shaft
Motor Shaft
SPARE PART LIST:
DYP-1023 10*6 Propeller
SWD-10
Spinner
SWD-11
Landing Gear
SWD-16 Cockpit
SWD-17 Moto Mount
SWD-12
Blade Holder
SWD-13 Plastic Parts
DYB-11 Pilot DY-3003 Glue
2
2
/
