*LY* Paging Selector
PB9810P
6
OPERATION
1. While press down any switch of CH1-CH10 on front panel with its indicator lit, the paging channel
will be switching on respectively. Press the switch again with the indicator getting off for resetting.
2. Pin 1-10 of ALARM IN to be connected to fire
center are the live terminals of CH1-CH10
respectively. And, Pin 11-25 are COMs (refer to
fig1). +12V to 24V - high level or 0V - low level
is available for alarm activating. While ACTIVE
LEVEL set at HIGH, high level is valid; while
ACTIVE LEVEL set at LOW, low level
(grounded signal) is valid.
3. Switch Address is for Remote only. If there are
more than one PB9810P in Remote System, they must be addressed with different priority each other.
How to set the switch ADDRESS please reference the table list:
NUM. DIP SET NUM. DIP SET NUM. DIP SET NUM. DIP SET
1 5 9 13
2 6 10 14
3 7 11 15
4 8 12 16
The gray block is indicated the place of the ADDRESS switch.
1 2 3 4 5 6 7 8 9 10 11 12 13
14 15 ,16 ,17 18 19 ,20 21, 22 23 ,24 ,25
fig.1