AQT-G3

AquaThrift AQT-G3 Installation guide

  • Hello! I am an AI chatbot trained to assist you with the AquaThrift AQT-G3 Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • Where is the filter cartridge holder located?
    How do I open the cartridge cover?
    How do I remove the old filter?
    How do I install the new filter?
    How often should I replace the filter?
    What should I do if the filter bypass plug is missing?
    What are the risks associated with small parts during filter replacement?
1
Locate the filter cartridge holder
in the back upper right hand
corner of the refrigerator. To
open the cartridge cover, push
in where indicated and the cover
will drop down.
2
Remove old filter by slowly
rotating it to the left. A small
amount of water may drip down.
3
Carefully remove the plug on top
of the new filter (twisting it back
and forth eases the plug out).
Be careful not to remove the
o-ring located under the plug.
IF THE O-RING IS MISSING,
PLEASE CALL (866) 218-8473
FOR HELP.
4
Position the cartridge inside the
cartridge holder and
slowly rotate the cartridge to the
right until it stops. When the
cartridge is properly installed,
you will feel it “click” as it locks
into place. The blade on the end
of the cartridge should be
positioned vertically. Do not
overtighten.
5
Close the cartridge cover.
6
Run water from the dispenser for
5 minutes at .5 gpm (about 2½
gallons) to clear the system and
prevent sputtering.
7
Reset the "replace filter" light.
Refer to your refrigerator owner's
manual for reset procedure.
8
Attach the included water filter
replacement calendar label
according to the label
instructions.
Installation Quick Start Guide for AQT-G3
Important Installation Instructions
9/2014 P/N 803085
RAM ASSOCIATES LLC • P.O. Box 3303 • Nashua, NH 03061
For further questions or assistance please call (866) 218-8473.
Monday - Friday 8am to 5pm Pacific Standard Time
WARNING
A newly-installed water filter cartridge may cause water to spurt from the dispenser until
all the air is removed. Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after the system.
Protect from freezing.
To reduce the risk of property damage due to water leakage, this filter MUST be
installed in accordance with the manufacturer’s specifications and instructions. This filter
must be replaced every 6 months, at the rated capacity, or sooner if reduced water flow
occurs. Failure to follow instructions and operation specifications will void your warranty.
Further, manufacturer assumes no responsibility or liability for damages arising out of
misuse of the product. The filter bypass plug MUST be used when a filter replacement
cartridge is not installed.
The risk associated with small parts can cause choking if swallowed. Keep children
away from small parts during the replacement of the water filter.
/