7
WARNING! Always secure an elevated P-6 with a safety wire
•
• Have a minimum gauge of 4 mm.
•
CAUTION!!
• Always use a safety wire.
• Make sure the slack of the safety wire is at a minimum.
• Never use the handle for secondary attachment.
Rigging process using SGM Omega brackets
1.
o f
2.
3. -
a
4.
5.
6. -
7.
Holes for omega bracket
Omega bracket
Figure 3: Base with omega bracket
Figure 4: Safety wire attachment point
1.
2. Adjust the tilt to the angle desired and hold it.
3.
enough.
CAUTION!!
Angle indicator
The angle indicator in the wheel shows the current angle of inclination.
NOTE: In POI versions, SGM provides a POI Spanner with a pig-nose key for tilt adjustment. Either use the large or the small
Tilt Lock
Pitch angle
indicator