1
Instruction
Danfoss Heating VICTE202 Heating Solutions
1 2
Attach the perimeter insulation with tape on wall.
Note! If additional insulation is 5 cm thick or more attach the perimeter
insulation on the additional insulation.
Begin laying insulation panels with the overlay flap upright against the
wall.
3 4
Observe the overlap throughout installation. Install insulation panels throughout all rooms.
5 6
Attach perimeter insulation, tension free, by using the self adhesive strips. Joints without any overlap should be taped up. When using liquid screed
tape overlapping joints.
Installation Guidelines for BasicClip
Produced by Danfoss A/S © 04/2009
VICTE202
Instruction Installation Guidelines for BasicClip
7 8
Tack down Danfoss composite pipe with two BasicClip clips per metre. Position tacker vertically over the required spot and fasten pipe by
pushing down the tacker handle.
9 10
Lay pipes in snail form throughout the room. Install expansion joint profile e.g. for door thresholds, as shown, using
the Basic movement gap strip.
/