Fluidmaster 6102 Installation guide

Brand: Fluidmaster

Model: 6102

Category: Sanitary ware

Type: Installation guide

STEP 1

STEP 2

STEP 3 STEP 4

BOLT

RUBBER WASHER

HEX NUT

WING NUT

TANK

BOWL

BRASS WASHER

RUBBER WASHER

BRASS WASHER

OPTIONAL

{

DO NOT USE:

INSTALLATION INSTRUCTIONS

:DEDEEN SLOOT

1. Turn off water supply. Flush toilet and remove excess water

from tank with sponge. Remove water supply line from bottom

of toilet fill valve.

2. Unbolt tank from bowl, then lift off tank. Remove washers and

nuts from bottom of tank, then remove old bolts. Remove old

gasket.

3. Slide new sponge rubber gasket (small side down) over nut

on threaded end of flush valve. Using diagram at left for

reference, install bolts as follows: Slide rubber washer under

bolt head and insert bolt through tank. Install brass washer,

then thread hex nut onto bolt. Carefully tighten bolt until snug.

4. Place tank back on bowl so that sponge gasket fits evenly.

Using diagram, install rubber washer, brass washer, then

wing nut onto bolt. Repeat for other side. Tighten nuts evenly.

DO NOT OVERTIGHTEN or bowl may crack. Reconnect

water supply line to toilet tank fill valve. Turn on water supply.

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675 U.S.A.

www.xthistoilet.com

instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be

liable for any damages resulting from failure to install or maintain the product in accordance

with the product instructions, from abuse or misuse of the product, from use of

non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl

cleaners containing bleach or chlorine.

Fluidmaster 6102 Installation guide

Brand: Fluidmaster

Model: 6102

Category: Sanitary ware

Type: Installation guide

Download PDF

report

Fluidmaster 6102 Installation guide

Fluidmaster 6102 Installation guide

Related papers

Other documents