Fluidmaster 6100 Installation guide

STEP 1

STEP 2

STEP 3 STEP 4

STEP 5

DO NOT USE:

INSTALLATION INSTRUCTIONS

:DEDEEN SLOOT

1. Turn off water supply and flush tank. Remove excess tank

water with sponge. Disconnect water supply line from tank

fill valve.

2. Unbolt tank from bowl by loosening nuts below toilet bowl. Lift

tank from bowl.

3. Remove old gasket. Slide new sponge rubber gasket (small

side down) over nut on threaded end of flush valve.

4. Place tank back on bowl so that sponge gasket fits evenly

and bolts line up tank to bowl. If bolts are worn, replace with

Fluidmaster model 6101 bolts or 6105 bolts.

5. Install rubber washer, metal washer, then nut onto bolt.

Repeat for second side of tank/bowl. Tighten nut evenly. DO

NOT OVERTIGHTEN or bowl may crack. Reconnect water

supply line.

30800 Rancho Viejo Road

San Juan Capistrano, CA 92675 U.S.A.

www.xthistoilet.com

instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be

liable for any damages resulting from failure to install or maintain the product in accordance

with the product instructions, from abuse or misuse of the product, from use of

non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl

cleaners containing bleach or chlorine.