Find the connector piece and use it to adjoin the 2 rod
segments. Then place a mounting clip (A) on the rod
connector and insert a screw into the hole. Screw and tighten
the connector onto the middle bracket.
Proceed to attach mounting clips to ends of the hanging rod
segments and attach them to the outter rod brackets with
screws.
Place nets on the rod brackets. Fasten the metal nets to
the brackets by placing 2 net clips (B) on each bracket (see
example below). Once you have done so, the shelf is
completed.
METAL WALL ANCHOR
INSTALLATION*
Drill a hole into the wall, using a 1/4”(6mm) inch
drillbit.
1 2
3
4
Tap the anchor into the hole until it is flush
with the surface of the substrate.
Attach drill or screwdriver to head of screw and
expand the anchor by tightening the head.
Remove the screw and place it
through the fixture then back into
the anchor. Tighten the screw until
the fixture is secure.
*USE ON 3/8”-1/2” THICK WALLS
ONLY!