Page is loading ...
1
2
3
Fig. 1
Fig.
2
Fig. 1
Fig.
3
Fig. 1
Fig. 4
Fig.
5
Fig. 7
Fig.8
Fig.9
SFS101B Spa Speaker Installation Instructions
Fig. 10
Fig. 11
Contents:
1. Speaker Assembly with Cable
2. Top Cover
3. Bottom Cover
4. Hardware
(4) Mounting Screws
(2) cover screws
(2) Rubber Caps
4
1
The Speaker assembly mounts to the Spa Skirt wall just
below the Bar top (Fig. 6)
The Speaker cable can be routed along the skirt top,
bottom or passed through the tub skirt. Cutouts (Fig.
2) are provided on the Trim covers to accommodate
the speaker cable exit. If you choose to rout the wire
inside the skirt a 1/2“hole is required for the
connectors. (Fig.3). Be sure the area behind is clear
before drilling.
. Before mounting the front trim cover must be in
place. (Fig.4)With the speaker in the middle position
gently insert the cover and snap into place. (Fig.5) be
sure all 5 contact points have snapped in place.
Find a suitable location (Fig.6) and mark the 4
mounting holes. Drill 4 1/8 “pilot holes and attach the
speaker to the Skirt with the 4 self tapping screws
provided.
The rear Trim cover can now be attached. Ease the
cover into place being sure to engage the tab on the
front cover (Fig. 8) then press the cover into place.
(Fig.9) Use the 2 machine screws to fasten the cover to
the mounting plate. (Fig.11)
Cover the screws with the rubber plugs provided. (Fig.
11)
Route the speaker wire as required and connect to
audio source
Cutouts
Fig. 6
1352 Charwood Road • Suite D • Hanover, MD 21076 • Tel (410) 761-4000 • Fax (410) 761-6274 www.polyplanar.com
/