1
Installation Instructions for
Audrie 1 Light Wall (LED)
1.2
WB1741-W 1742B
W 1741, W 1742BB
Align the anchors with the mounting plate holes and install them by pushing them into the wall.
Secure the mounting plate to the electrical box with two mounting plate screws.
Screw the anchor screws into the anchors.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the red and blue driver wires to the appropriate fixture wires with wire nuts.
Connect the white driver wire to the neutral power line wire with a wire nut.
Connect the black driver wire to the hot power line wire with a wire nut.
Neatly place the driver and wires into the electrical box and/or fixture, then mount the fixture base onto the mounting
plate and secure it with the fixture screw.
1
2
3
1A
FIXTURE
4
ELECTRICAL BOX
MOUNTING
PLATE
5
FIXTURE SCREW
Wall
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant
junction boxes.
This product is safety listed for damp locations.
This instruction shows a typical installation.
CAUTION - RISK OF FIRE
This product must be installed in accordance with
the applicable installation code by a person familiar
with the construction and operation of the product
and the hazards involved.
Use minimum 90°c supply conductors.
MOUNTING
PLATE SCREW
DRIVER
6
ANCHOR
SCREW
ANCHOR
2
2
8
8
5
5
6
7
7
8
1
3
Page is loading ...
Page is loading ...
SAVETHESE INSTRUCTIONS!
4
7400 Linder Ave, Skokie, IL 60077
800.969.3347
www.Feiss.com
© 2015 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
/
