Dymo Label Buddy User manual

Label Blaster/Label Buddy Guide

Extend the embossing tape about one

inch. This will allow for easier loading

into the Label Blaster/Label Buddy.

Push in and upward on the tab located on

the back of the Label Blaster/Label Buddy.

This will allow you to open the door to the

tape compartment.

Squeeze the handle two more times

to continue feeding the tape through

the unit.

Insert the embossing tape into the slot

located in the tape compartment.

Feed the tape in as far as you can.

Squeeze the handle two times to help

feed the tape through the unit. Place

the embossing tape in the tape

compartment and close the

compartment door.

Select the following symbol:

Turn the wheel to select different

characters. Once you have selected

the character you’d like to emboss,

firmly squeeze the handle on the

Label Blaster/Label Buddy.

Remove the backing and apply the

tape to the desired surface.

Firmly squeeze the handle to cut the

tape.