Beghelli BLS-2A Installation guide

Type
Installation guide

This manual is also suitable for

MODEL INFORMATION
INSTALLATION INSTRUCTIONS
LUCE SOLARE®
BLS-2A, 4A, 6A, 8A,10A
LUMENS 1630lm, 3259lm, 4888lm, 6518lm, 8148lm
LUCE SOLARE BLS-2A, 4A, 6A, 8A, 10A
10.2AH, 18.2AH, 28.6 AH, 39AH, 46.8AH
OUTDOOR
SOLAR
0° C(32° F)/45° C (113° F)
-20° C(-4° F)/60° C (140° F)
LIGHT INDICATOR WILL BLINK 3 TIMES EVERY 15 MIN. DURING NIGHT
SOUTH 100%; EAST 75%; WEST 70%; NORTH 46%
10-12 hrs
9-11 hrs
3 DAYS OF CHARGING BATTERIES WITH FIXTURE ON “OFF MODE
BATTERY CAPACITY
WET LOCATION
LOCATION
CHARGING OPERATION TEMP.
DISCHARGING OPERATION TEMP.
INDICATOR FOR ONE NIGHT OPERATION
CHARGE TIME
INITIAL CHARGE TIME
DISCHARGE TIME
PERFORMANCE ORIENTATION
NOTE: INITIAL INSTALLATION - MINIMUM 3 DAYS OF CHARGING BATTERIES WITH FIXTURE IN “OFF” MODE.
www.beghelliusa.com 06/30/23
www.beghelliusa.com
A
C
B
BLS-2A
BLS-4A
BLS-6A
BLS-8A
BLS-10A
A
15°
15°
15°
2.3 ft
2
EPA
3.2 ft
2
4.5 ft
2
6.4 ft
2
6.4 ft
2
19.8 lb
WEIGHT
24.6 lb
27 lb
45 lb
47.4 lb
11.9 in
B
11.9 in
15 in
15 in
15 in
37.9 in
C
37.7 in
52.2 in
61.5 in
61.5 in
NOTES:
Luminaire cannot be adjusted on the horizontal plane.
Proper orientation directly effects performance.
Increased direct sunlight to the solar panel increases performance.
TIPS FOR OUTDOOR LIGHTING
NOTE: LIGHT INDICATOR FLASHES 3 TIMES EVERY 15 MINUTES DURING
NIGHT, INDICATING THE BATTERY CAPACITY WILL LAST FOR ONE NIGHT.
LUCE SOLARE INSTALLATION INSTRUCTIONS
Outdoor Solar Lights have the advantage of providing an energy free lighting solution. Despite the simplicity of the design, they do sometimes
develop problems. The good news is that most of the problems are easy to troubleshoot and fix or can be avoided if known in advance.
TEMPERATURE
• Below 0 degrees, may cause the battery to fail (for charging).
• Higher than 45 degrees, may cause the battery to fail (for charging).
WEATHER
Cloudy or rainy weather will inhibit proper battery charging and may cause the product to not perform as expected. These conditions
can reduce light output, not light at all, or create a strobe effect. This does not mean there is a quality issue, the product simply requires
direct sunlight to properly charge.
ENVIRONMENT
Dust, bird droppings, insect carcasses and other debris attached to the solar surface will reduce charging efficiency, and can cause
inefficient charging and / or damage to the solar panel.
PHOTOSENSITIVE ELEMENTS
Other light sources may be detected by the integrated sensor. This may cause the luminaire to function incorrectly and / or not turn on.
RIGHT INSTALLATION
Initial installation out of box requires minimum 3 days of charging batteries with fixture on “offmode.
• Inconsistencies in installation; such as varying orientations and inclinations may cause inconsistent charging, resulting in varying brightness.
• Shadows created by surrounding buildings, trees, or other objects may decrease the efficiency of the solar panel, limiting the batteries
charging level. Different levels of battery charge may result in varying brightness and duration.
STANDARD BRACKET MOUNTING
MOUNTING SCREWS
(PROVIDED)
MOUNTING BRACKET
OPERATION MODES
LIGHT INDICATOR
OPERATION MODES
SWITCH
SET SCREWS (PROVIDED)
SLIP-FIT FOR 2.75”
O.D X 5” LONG TENON
2.75” O.D X 5” TENON
/POLE (BY OTHERS)
www.beghelliusa.com 06/30/23
*PUSH AND HOLD OPERATION MODES SWITCH TO TURN FIXTURE ON/OFF.
MODE 1 (GREEN LIGHT): 5HRS @100% + 7HRS @30% + PIR @100%
MODE 2 (ORANGE LIGHT): 5HRS @70% + 7HRS @30% + PIR @100%
MODE 3 (RED LIGHT): 12HRS @ 30% + PIR @ 100%
  • Page 1 1
  • Page 2 2

Beghelli BLS-2A Installation guide

Type
Installation guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI