Krown Manufacturing Nursery Room Transmitter User manual

Krown Manufacturing
Brand
Krown Manufacturing
Model
Nursery Room Transmitter
Type
User manual
KA1000NR
Nursery Room Call Transmitter
Instruction Booklet
01.E.2014-05-01
LOCATION: Krown Manufacturing, Inc.
3408 Indale Road, Fort Worth, TX 76116, United States of America
OFFICE: +1 (817) 738-2485 (voice/TTY)
VP: +1 (682) 200-1331
FAX: +1 (817) 738-1970
EMAIL: [email protected]
Battery replacement recommended every 6 months
or when a low battery condition exists
• The KA1000NR has a low battery detect feature and the LED
will turn RED during transmission.
• The display of the KA1000 and the RED LED on the
KA1000RR will also flash when receiving a signal from a
transmitter with a low battery condition.
™
ACCESSIBLITY , INNOVATION & DESIGN FOR ALL
MANUFACTURING
CH3
CH2
CH1
1 2 3 4 5 6 7 8 9 10
9V BATTERY
KA1000NR - Nursery Room Call Transmitter Getting Started - Transmitter pairing and testing
• Remove back casing of the unit and verify 10 position code
switch matches with the corresponding receivers. (KA1000
alarm clock receiver or KA1000RR remote receiver)
• Install 9 volt (1604 type) battery and turn on the unit. (Slide the
POWER switch to the ON position).
• Press the TEST button of the unit for a minimum of 3 seconds.
The LED indicator will turn ORANGE when the unit is transmit-
ting for 3 seconds or more.
• Ensure the corresponding receiving unit activates indicating a
received signal from the KA1000NR transmitter.
Placement
• Place the KA1000NR with MIC (microphone) as close to the
baby as possible and not more than 5 feet away.
• Place the KA1000NR with the MIC (microphone) pointing
towards the source of the sound, audio alarm, or door chime
being monitored.
Sensitivity adjustment
• Activate the device being monitored. (e.g. chime/alarm) the
LED will illuminate GREEN when the MIC picks up sound.
• If the LED does not come on then move the sound sensitivity
adjustment to a “HIGH” sensitivity level and test again.
• If the MIC is triggered for 3 seconds or more the LED of the unit
will illuminate ORANGE.
LED
Sensitivity
Adjustment
HIGH
LOW
ON
OFF
MIC
Power Switch
Channel
Open
back case
Position Code Switch
TEST
CH3
CH2
CH1
1 2 3 4 5 6 7 8 9 10
9V BATTERY
KA1000NR - Nursery Room Call Transmitter Getting Started - Transmitter pairing and testing
• Remove back casing of the unit and verify 10 position code
switch matches with the corresponding receivers. (KA1000
alarm clock receiver or KA1000RR remote receiver)
• Install 9 volt (1604 type) battery and turn on the unit. (Slide the
POWER switch to the ON position).
• Press the TEST button of the unit for a minimum of 3 seconds.
The LED indicator will turn ORANGE when the unit is transmit-
ting for 3 seconds or more.
• Ensure the corresponding receiving unit activates indicating a
received signal from the KA1000NR transmitter.
Placement
• Place the KA1000NR with MIC (microphone) as close to the
baby as possible and not more than 5 feet away.
• Place the KA1000NR with the MIC (microphone) pointing
towards the source of the sound, audio alarm, or door chime
being monitored.
Sensitivity adjustment
• Activate the device being monitored. (e.g. chime/alarm) the
LED will illuminate GREEN when the MIC picks up sound.
• If the LED does not come on then move the sound sensitivity
adjustment to a “HIGH” sensitivity level and test again.
• If the MIC is triggered for 3 seconds or more the LED of the unit
will illuminate ORANGE.
LED
Sensitivity
Adjustment
HIGH
LOW
ON
OFF
MIC
Power Switch
Channel
Open
back case
Position Code Switch
TEST
KA1000NR
Nursery Room Call Transmitter
Instruction Booklet
01.E.2014-05-01
LOCATION: Krown Manufacturing, Inc.
3408 Indale Road, Fort Worth, TX 76116, United States of America
OFFICE: +1 (817) 738-2485 (voice/TTY)
VP: +1 (682) 200-1331
FAX: +1 (817) 738-1970
EMAIL: [email protected]
Battery replacement recommended every 6 months
or when a low battery condition exists
• The KA1000NR has a low battery detect feature and the LED
will turn RED during transmission.
• The display of the KA1000 and the RED LED on the
KA1000RR will also flash when receiving a signal from a
transmitter with a low battery condition.
™
ACCESSIBLITY , INNOVATION & DESIGN FOR ALL
MANUFACTURING
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Krown Manufacturing Nursery Room Transmitter User manual

Krown Manufacturing
Brand
Krown Manufacturing
Model
Nursery Room Transmitter
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents