web: www.smar.com/contactus.asp
www.smar.com
Specifications and information are subject to change without notice.
Up-to-date address information is available on our website.
smar
Detail 1
Step 4: Replace the Firmware memories U7 and
U8.
Remove the memory chips from the socket.
Be careful not to damage the socket or the
pressed circuit track located underneath.
Remark: The sockets have 2 cavities for
in
se
r
t
i
o
n
o
f
t
h
e
e
x
t
r
act
i
o
n
too
l.
Extraction tool insertion point
Step 2: Connect one end of the
“wire wrap” on connector J2 fifth
pin.
Detail 2
Detail 2A
Detail 1A
Detail 1B
Step 1: Interrupt the track that leads
to the 5th pin of J2
connector. (from the top)
Step 3: Connect the other end of the
“wire wrap” on the spot right above
CD1.
Replacement of the Front Panel and the CD600 cards
The GLL601 and GLL610 cards will be replaced by the GLL1252 and GLL1253
cards. In order for these new cards to be used, a few adaptations will be needed on
the GLL600. These changes consist on the update of the firmware version from
2.02 to 3.04, and on the J2 connector, the 26th pin should be disconnected from the
“A10” signal and connected to the “/RST” signal, as detailed below.
Remarks:
- Make sure to backup the configuration before the adaptation, because with the
firmware change the configuration will be lost.
- The GLL 600 card Rev.: 05 is already adapted.
- This page is better seen on the web site: www.smar.com/products/cd600.asp
Included Items on the Set:
-“Wire Wrap”
-2 memory chips (Firmware 3.04)
-Complete front set (ref.:400-0634)
or
-Cards only set (ref.:400-0635)
If there is any doubt please contact us: [email protected] or by the phone
on the cover of this manual.
-
1
-
2
