LED Job Site Light
Important: Read all instructions prior to installation. TJSL-xKx
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V0.1 01/10/2022
Specications
Hanging Latch Instructions
Linking Instructions
User Manual
Model TJSL-xK60W TJSL-xK100W TJSL-xK120W
Operating Temperature -40°–113° F (-40°–45° C)
IP Rating IP65¹
Fixture Weight 4.45 lb (2 kg) 4.85 lb (2.2 kg) 5.25 lb (2.4 kg)
Max Run (10 A) 20 12 10
Built-in latch will accommodate pipe or cable up to 0.5” diameter.
¹not applicable when linked
Lights can be linked in a run which uses 10 A or less of total current. The
number of lights will vary based on part number (see spec table above).
When linking lights, make sure safety clip is fully engaged to ensure
cord cannot accidentally become unplugged.
Safety and Notes
• This product should be installed in accordance with
applicable national, state, and local building and
electrical codes.
• To reduce the risk of electric shock, ensure that the
main power source and circuit breakers are switched
o before performing any installation.
• Avoid looking directly into the lamp when illuminated.
• Ensure mount is securely attached and will support
the weight of the xture. Failure to properly support
the xture may result in damage or injury, for which the
manufacturer does not assume responsibility.
• Supply power can be linked (see spec table for max
run).
• Do not install in a location that is in proximity to a
radiant heater.
5yr
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Super Bright LEDS LSFD-SW3C40W-H User manual
-
Kenwood KAX941PL Owner's manual
-
-
Sears 13953970SRT User manual
-
Anolis ArcPad™ 48 Integral User manual
-
Robe CitySkape 48 User manual
-
-
-
-