Verkada ACC-MNT-CORNER-1 Installation guide

  • Hello! I'm a chat assistant and I've reviewed the install guide for the Verkada Corner Mount ACC-MNT-CORNER-1. This document provides step-by-step instructions for mounting the corner mount, including the required hardware and tools. There are instructions for drilling holes and securing the corner mount using sleeve anchors. I am ready to assist you with any questions you have about this document and the corner mount.
  • What drill bit size is needed for sleeve anchors?
    What is the minimum drill depth for the pilot holes?
    Where can I find specific mounting instructions for Verkada products?
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
All specifications are subject to change without notice
© Copyright 2023 Verkada Inc. All rights reserved.
Install Guide
ACC-MNT-CORNER-1
Corner Mount
Introduction
What’s in the box
What you’ll need
A compatible Verkada product
1/2 inch (12.7mm) drill bit, or larger, for
routing cable through wall
5/16 inch (7.9mm) drill bit for sleeve anchors
13/32 inch (10mm) wrench for nuts
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
All specifications are subject to change without notice
© Copyright 2023 Verkada Inc. All rights reserved.
ACC-MNT-CORNER-1
Compatible products
For a list of compatible products,
please visit:
https://docs.verkada.com/docs/a
ccessories-overview.pdf
2
M4x0.7 Machine Screw (4 pcs)
Length: 14mm Drive: #2 Phillips
1/4”-20 Sleeve Anchors (4 pcs)
Length: 2-3/4” Drill Size: 5/16"
Introduction
Hole Patterns
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
All specifications are subject to change without notice
© Copyright 2023 Verkada Inc. All rights reserved.
3
1
2
3
4
5
CD/CF series, Verkada mounts
CB series
CM series
ACC-CAM-SHIELD-1
ACC-MNT-XLARM-1
Mounting
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
All specifications are subject to change without notice
© Copyright 2023 Verkada Inc. All rights reserved.
4
Installation
Wall Mounting
Drill 5/16” pilot holes to a minimum depth of 1-¼”.
Clear the hole of debris and insert the sleeve anchors from
Hardware Bag A into the pilot holes using the sidemost slots.
Fully secure the corner mount by attaching nuts and
tightening them.
Camera & Accessory Mounting
For detailed mounting instructions related to Verkada
products, please see their install guide.
Appendix
Support
Verkada Inc. 405 E 4th Ave, San Mateo, CA 94401
All specifications are subject to change without notice
© Copyright 2023 Verkada Inc. All rights reserved.
Thank you for purchasing this Verkada product. If for any reason
you're experiencing issues or need assistance, please contact our
24/7 Technical Support Team immediately.
Sincerely,
The Verkada Team
verkada.com/support
5
/