10mm 3x3 Tower Block Foyer
B10-CS-209
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Foyer
Remove the inner front wall, its “roof” and two
door frames from the sprue.
Attach the wall to the “roof” then glue the door
frames in position as shown.
Now remove the two side walls from the sprue.
Glue the side walls to the inner front wall assembly,
aligning it using the holes/lugs provided.
Glue the outer front wall into place.
Then attach the back wall.
Glue the whole model to the base. Note there is
a “B” etched into the base which should be at the
back of the building.
Glue the door frames around the side doors and on
the back of the building.
Finally glue the sun-screens into place (etched
detail upwards).
10mm 3x3 Tower Block Middle
B10-CS-262
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Middle Section
Take the four walls and base from the sprue.
Glue the walls to the base as shown, aligning them
using the holes / lugs provided.
Flip the whole thing upside down and glue the
support lugs into place.
Take the twelve sun-screen strips from the sprue and
attach three to each side of the building as shown
above.
10mm 3x3 Tower Block Roof
B10-CS-310
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due
care and remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold
pieces in place while you allow glue to dry.
Roof Section
Remove the base and four walls from the sprue.
Glue the walls to the base, aligning them using the
holes / lugs provided.
Flip the roof assembly over and glue the four
support pieces into place as shown.
Put it back the right way up and attach the four sun-
shade pieces.
-
1
-
2
-
3
-
4
BLOTZ B10_CS_015 Quick start guide
- Type
- Quick start guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
BLOTZ B15-ME-111 Assembly Instructions
-
BLOTZ B28-OW-520 Assembly Instructions
-
BLOTZ B06-CS-009 Assembly Instructions
-
BLOTZ B15-SR-001 Assembly Instructions
-
BLOTZ B28-DA-103 Assembly Instructions
-
BLOTZ B15-OW-002 Assembly Instructions
-
BLOTZ B10-CS-305 Assembly Instructions
-
BLOTZ B28-ST-147 Assembly Instructions
-
BLOTZ B10_ME_007 Assembly Instructions
-
BLOTZ B06-CS-010 Assembly Instructions
