meitav-tec FMH-24-PD-1S Owner's manual

Type
Owner's manual
- 1 -
File: fmh24-pd-1s-A4-rev1.doc
Rev. 1 Date:07/06/2005
FMH24-PD-1S-IR
Owner's Manual - Installation and Operating Instructions
Please read this manual carefully before installation and use.
Index
Installation Instructions 1
Wiring Connections 2
Operating Manual 3
1. Installation Instructions
Is very important to find the right place to install the Flush Mount unit.
Please make sure to follow all the installation instructions in order to get an
accurate reading of the temperature.
General points to follow:
The unit MUST be fitted into a standard electrical box (Gewiss Box - GW00001481VR)
The unit should not be installed on an outside wall or where there is an air draft.
The unit must not be exposed to a direct sunlight.
The standard height to install this unit is 1.5 meter from the floor (5 feet).
Installation procedure:
Connect the wires (see #2)
Put the thermostat in the electrical box.
Meitav-tec Ltd (Contel group)
Tel: 972-3-9626462 Fax: 972-3-9626620
www.meitavtec.com - support@meitavtec.com
- 2 -
File: fmh24-pd-1s-A4-rev1.doc
Rev. 1 Date:07/06/2005
Y
Proportional
output for
cool and heat
R
HI
C
24Vac
FAN
Tighten up the 2 screws.
Adapt the front frame-panel into its place, by pushing it towards
the wall.
2. Wiring Connections
3. Operating Manual
3.1 Switching the thermostat On
1. Press the ON button to activate the thermostat.
2. ON will appear on display.
3.2 Switching the thermostat Off
1. Press the OFF button to deactivate the thermostat.
2. OFF will appear on display.
3.3 Setting the temperature
1. Press the (+) or (-) the temperature will flash.
2. Change the set temperature using the (+) or (-) buttons.
3.4 Selecting modes
1. Press the MODE button to switch between:
Cool
Heat
Fan only
Switch
Y
0
Empty
Empty
R
C
HI
Empty
Empty
  • Page 1 1
  • Page 2 2

meitav-tec FMH-24-PD-1S Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI