CLS Jade B ColourFlow Owner's manual

Brand
CLS
Model
Jade B ColourFlow
Type
Owner's manual
www.cls-led.com www.cls-led.com
Ceiling 350º 50.000 h IP20
30 Watt
Max.
360º 23º 45º 69º
100 - 240
VAC
DRIVER
INCLUDED
DRIVER
INTERNAL
780 gram
DMX
512
RGB-W 1800K-
4000K
2700K-
5700K
CLS
DYNAMIC
COLOUR
COB
10 mm 200 cm
ø
2
CLS JADE B COLOUR FLOW - TUNABLE WHITECLS JADE B COLOUR FLOW - TUNABLE WHITE
Manual V1.1 - November 2020
INDEX
CONTENT
SAFETY INFORMATION
Ambiance
Max. 40º
Block access
below the work
area when
maintaining
the unit
Use a source
of AC power
that complies to
local electrical
codes
Disconnect the
power supply
before installing
or maintaining
Don’t install in
a flammable
or explosive
area
Warning!
Some surfaces
can be hot
Do not stare
into the LED
Don’t modify
or install
genuine parts
on this product
Qualified
technician
Make sure all
connectors are
connected
properly
Ceiling 350º 50.000 h IP20
30 Watt
Max.
360º 23º 45º 69º
100 - 240
VAC
DRIVER
INCLUDED
DRIVER
INTERNAL
780 gram
DMX
512
RGB-W 1800K-
4000K
2700K-
5700K
CLS
DYNAMIC
COLOUR
COB
10 mm 200 cm
ø
CLS JADE B COLOUR FLOW - Tunable WhiteCLS JADE B COLOUR FLOW - Tunable White
Index 2
Safety information 2
Content 2
Technical 3
Specifications 3
Installation 4
Programming 5
Factory setting table 5
Programming table 6
Barndoor assembly 7
Snoot / half snoot assembly 8
Honey comb assembly 9
Accessories 10
Accessory combinations 10
List of symbols 11
www.cls-led.com www.cls-led.com
3 4
TECHNICAL
SPECIFICATIONS
LED: CLS Dynamic Colour CoB
Colour changing: RGB-W
Tunable White: 1800-4000K & 2700K-5700K
Beam angle: 23º, 45º or 69º
Power supply: 100 ~ 240 VAC
Power consumption: Max. 30 Watt (1450 lumen)
Housing: Black, grey or white PC (PC-ABS V0)
Heatsink black or white coated aluminium
Weight: 780 gram
IP value: IP20
Cable length: 200 centimeters
Measurements: 175,7 x 100 x 100 mm (hxwxd)
Ambient temperature: -10º C till +40º C
Tools ø 10 mm
75 mm
122,5 mm
157,7 mm
ø 100 mm
18 mm
ø 10 mm
75 mm
3
1
4
350º
360º
* Install example aluminium cable tray
2
ø 10 mm
5
Position
indicator
65 core combi cable connection scheme
yellow/green
Brown
Blue
Red
White
- Combi cable = 5 x 0,5 mm2
- Max. 20 Jade B Colour Flow - Tunable White in 1 power line
INSTALLATION
www.cls-led.com www.cls-led.com
65
PROGRAMMING
PROGRAMMINGTABLE
DMX
Function
Data
Parameters
CH1
Setaddress
001to255
0
0=nochange
1…255
DMXaddress=1…255
CH2
Setaddress
256to508
0
nochange
1…255
DMXaddress=256…508
CH3 Static
behavior
0
nochange
IfnoDMXispresentthefixturewillrespondlike
setinthisfunction.
1
lastDMXvalue
2
outputoff
3
loadstaticvalues
CH4 Softdim
0
nochange
values.Thisfunctionmakesthedimcurve
1
off
2
on
CH5 Master
control
0
nochange
willbeDMXchannel“n”.Ifmasterislastchannel
isselectedthechannelwillbe“n+x”
(“x”iscalculatedintheoutputpatch).
1
nomasterused
2
masterisfirstchannel
3
masterislastchannel
CH6 Output1
patch
0
nochange
Eachoutputchannelcanbepatchedtorespond
tothedesiredDMXchannel.Thisenablesthe
usertomixupthecoloursaccordingtothe
controllerthatisused.
Example:alloutputsarepatchedas1
AlloutputswillbecontrolledbyDMXchannel
“n”.IfmasterisusedtotalDMXchannelswillbe2
otherwiseituses1channel(“x”=1).
Example:output1&2arepatchedas1and3&4
arepatchedas2
Output1&2willbecontrolledbyDMXchannel
“n”.
Output3&4willbecontrolledbyDMXchannel
“n+1”.
IfmasterisusedtotalDMXchannelswillbe3
otherwiseituses2channels(“x”=2).
1
DMXchanneln
2
DMXchanneln+1
3
DMXchanneln+2
4
DMXchanneln+3
CH7Output2
patch
0
nochange
1
DMXchanneln
2
DMXchanneln+1
3
DMXchanneln+2
4
DMXchanneln+3
CH8 Output3
patch
0
nochange
1
DMXchanneln
2
DMXchanneln+1
3
DMXchanneln+2
4
DMXchanneln+3
CH9Output4
patch
0
nochange
1
DMXchanneln
2
DMXchanneln+1
3
DMXchanneln+2
4
DMXchanneln+3
CH10Staticoutput
1
0
nochange
Eachoutputchannelcanbesettoanstatic
intensity.
IfnoDMXispresentandStaticbehaviorissetto
“loadstaticvalues”.Theoutputswillbesettothe
configuredintensityvalues.
1
outputoff
2…255
intensity2…255
CH11Staticoutput
2
0
nochange
1
outputoff
2…255
intensity2…255
CH12Staticoutput
3
0
nochange
1
outputoff
2…255
intensity2…255
CH13Staticoutput
4
0
nochange
1
outputoff
2…255
intensity2…255
CH14Loaddefault
settings
0
nochange
ThisfunctionresetsallsettingstotheFactory
setting.CheckFactorysettingtable.
X
LoadFactorysettings.Xisrow
numberfactorysettingtable.
PROGRAMMING TABLE
123
* If the LEDs ashes 10 times, something went wrong. Please try again. If the problem continues to occur, please contact your local sales distributor.
After 2 seconds
the LED will ash
3 times
conrming
storage*
Place magnet
at the bottom
of the Jade.
The LED will
light up
FACTORY SETTING TABLE
All settings can be configured via DMX. Settings can be configured at once or separately. When one or a couple settings needs to be
changed just leave all other setting values zero. This keeps those settings unchanged. Please check the table for more information.
Always use a DMX controller with digital interface. If not available, you can purchase the CLS D-ta DMX addresser unit (
#122200
).
First make sure to set the DATA on the DMX controller. To program the setting into the LED fixture follow the next steps.
Max. 20 pieces of Jade per DMX line on a rail.Max. 20 pieces of Jade can be connected in a group.
WIRELESS DMX
See the Manual of WIreless Solutions. The Manual can be found on our CLS website, in the Downloads section. Or use the link below
https://www.cls-led.com/wp-content/uploads/cls-files/W-DMX-manual.pdf
Unlink procedure
When the fixture does not receive a DMX signal (DMX controller off), place the magnet on the bottom of the fixture for 5 seconds.
Slow flash indicates that the fixture is unlinked.
www.cls-led.com www.cls-led.com
7 8
1
4
3
6
disassembly
Accessory holder
Barndoor
Removing the barndoor: rotate the accessory
holder fully to the right or left, until you are
not able to rotate it any further.
Verwijderen van de barndoor: draai de
accessoire houder geheel naar links of naar
rechts tot deze niet meer verder kan.
If you want to rotate the barndoor to find the desired position,
you need to keep the accessory holder with one hand on its place.
If you don’t do this you might release the accessory holder!
Als u de barndoor wilt roteren voor een juiste positie, dient u
dit met 1 hand te doen en met de andere hand de accessoire
houder op zijn plaats te houden.
Doet u dit niet, dan kunt u de accessoire houder losklikken!
When you feel the resistance, pull the accessory
holder out of the mountingslot.
U voelt een weerstand en kunt nu de accessoire
houder naar voren halen.
Plaats de accessoire houder met de 4 klikvingers in
het midden van de montage gleuf op de Jade.
Place the accessory holder with the 4 click fingers
in the middle of the mounting slot on the Jade.
NL
UK Push firmly until you hear a clear ‘Click’ sound.
Druk krachtig aan, u dient een duidelijke
‘klik’ te horen.
2
5
BARNDOOR ASSEMBLY SNOOT / HALF SNOOT ASSEMBLY
1
5
4
2
3
6
disassembly
Accessory holder
Snoot
Removing the snoot: rotate the accessory holder
fully to the right or left, until you are not able to rotate
it any further. (See step 5)
When you feel the resistance, pull the
accessory holder out of the mountingslot.
www.cls-led.com www.cls-led.com
9 10
HONEY COMB LOUVRE ASSEMBLY
1
5
4
2
3
6
disassembly
Accessory holder
Honey Comb Louvre
Removing the honey comb: rotate the accessory holder
fully to the right or left, until you are not able to rotate
it any further. (See step 5)
When you feel the resistance, pull the
accessory holder out of the mountingslot.
Facing towards
the Jade
ACCESSORIES
ACCESSORIES
122200 CLS D-Ta DMX tester/addresser unit
Y106017 CLS Magnet pin (5 pcs)
Y106200-B CLS Jade Expo Snoot, black
Y106200-W CLS Jade Expo Snoot, white (black inside)
Y106201-B CLS Jade Expo Half Snoot, black
Y106201-W CLS Jade Expo Half Snoot, white (black inside)
Y106202-B CLS Jade Expo Barndoor, black
Y106202-W CLS Jade Expo Barndoor, white (black inside)
Y106215 CLS Jade Expo Honey Comb louvre
Accessory Combinations
www.cls-led.com www.cls-led.com
11 12
LIST OF SYMBOLS
Multiple connection
Daisychain connectivity
Installation depth
In centimeters
Swivel
Fixture is horizontally rotatable,
indicated in degrees
Swivel
Fixture is vertically rotatable,
indicated in degrees
Installation size
In centimeters
Application area
Indoor or outdoor
Application area
Floor, wall or ceiling
Protection class
One, two or three
Cable length
Maximum cable attached
to the fixture in centimeters
Lifespan
Of the light source in hours
Driver
Inclusive or exclusive
Internal or external
Pressure
Maximum pressure on the
fixture in kg/cm2
Weight
In grams/kilograms
Curve
Minimal bending curve
in centimeters
LED pitch
Pitch between the LEDs
in millimeters
Power supply
In VDC, VAC or milliAmpere
Power consumption
In VA or Watt
IP value
Ingress Protection classifies the
degrees of protection provided against
the intrusion of the product
Cutting length
Indicated by the cutting
marks
LEDs
Kind of LED used in the
fixture
Lenses
Availble lenses,
indicated in degrees
Performance Zoom
Adjustable beam angle
Plug & play
Easy connection using the
SmartConnect system
White colour temperature
In dierent Kelvin values;
Cold white, neutral white, warm
white or extra warm white
Colour
Available colours;
Amber, blue, red or green
Colour changing
RGB, RGB-W, RGB-A,
AWB or Tunable White
DMX input
Fixture works on DMX512
protocol or Wireless DMX
Magno dimming
Accurate dimming from
100 - 1% by using a magnet
Dynamic Control
Dynamic Power Control or
Dynamic Temperature Control
Combined product
Compose your own fixture
Warranty
3 or 5 years warranty on
the product
Energy label
Conformité Européenne
CE marking for free marketability
of industrial goods within the EU
r
h
ø w d
Dimmable
1-10 Volt, Phase, individual,
DMX dimmable or DALI
DRIVER
INCLUDED
DRIVER
EXTERNAL
Retail & Food LED modules
Clothing, furniture, kitchens, jewellery,
shoes, bread, meat, fish and
vegetables & fruit.
Lightsource
Equipped with a CLS, Citizen or a Xicato
LED module
Bluetooth controlled
By Casambi
PWM dimming
Traditional PWM dimming, DMX analog
or DMX Hybrid dim
CLS
DYNAMIC
COLOUR
COB
2019 CLS-LED BV. All rights reserved. Information subject to change without notice, CLS-LED BV and all aliated companies disclaim
liability for injury, damage direct or indirect loss, consequential or economic loss or any other loss occasioned by the use of, inability to
use or reliance on the information contained in this manual. No part of this manual may be reproduced, in any form or by any means,
without permission in writing from CLS-LED BV. Other legal information can be found in our General conditions, found on the back of
your CLS-LED BV invoice, inside the CLS catalogue or on our website www.cls-led.com/General-Terms.pdf
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

CLS Jade B ColourFlow Owner's manual

Brand
CLS
Model
Jade B ColourFlow
Type
Owner's manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents