Lumination Tela Mini Series Snoot Accessory Installation guide

Lumination
Brand
Lumination
Model
Tela Mini Series Snoot Accessory
Type
Installation guide
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 1 of 2
(Rev 06/05/23)
IND433-Lumination-Tela-Mini-Snoot-Accessory-Installation-Instructions_R01
Installation Guide
IND433
Lumination® Tela Mini
Snoot Accessory
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT SAFETY
INSTRUCTIONS
When installing or using this track system, basic safety
precautions should always be followed, including the
following:
a. Read all instructions
b. Do not install this track in damp or wet locations.
c. Do not cut any track sections.
d. Do not install any part of a track system less than 5
feet above the oor.
e. Do not install any luminaire assembly closer than
6 inches from any curtain, or similar combustible
material.
f. Disconnect electrical power before adding to or
changing the conguration of the track.
g. Do not attempt to energize anything other than
lighting track luminaires on the track. To reduce the
risk of re and electric shock, do not attempt to
connect power tools, extension cords, appliances, and
the like to the track.
h. Do not connect a track to more than one branch
circuit unless the track is constructed so that it can be
used with more than one branch circuit. Check with
a qualied electrician. Although the track lighting
system may seem to operate acceptably, a dangerous
overload of the neutral may occur and result in a risk
of re.
SAVE THESE INSTRUCTIONS
For future reference when adding xtures
or changing the track conguration.
FOR USE WITH CEILING MOUNTED TRACK ONLY.
READ TRACK MANUFACTURER’S INSTALLATION
INSTRUCTIONS FOR GUIDELINES ON TRACK
INSTALLATION.
SKU
Material
Description
Product
Description
93026697 LTMSNWHTE LTM WHITE SNOOT
93026906 LTMSNBLCK LTM BLACK SNOOT
95019410 LTMSNSLVR LTM SILVER SNOOT
WARNING
RISK OF ELECTRIC SHOCK
Turn power o before inspection, installation or removal.
LED.com
© 2023 Current Lighting Solutions, LLC. All rights reserved. Information and specifications subject to change
without notice. All values are design or typical values when measured under laboratory conditions.
Page 2 of 2
(Rev 06/05/23)
IND433-Lumination-Tela-Mini-Snoot-Accessory-Installation-Instructions_R01
Lumination® Tela Mini Installation Guide
Installation of Snoot on the Tela Mini Series Track Light
Gently push the snoot inside the
accessory ring until it snaps into
place, so that it sits evenly inside the
ring. If the LTM xture is equipped
with Whiter White, the glass lens
should sit on top of the snoot.
Place the accessory ring back inside
the cap, snoot rst.
Begin with xture disconnected
from the track.
Unscrew the top of the xture and remove the cap and black plastic accessory
ring.
Accessory ring
Cap
Snoot
Accessory ring
Glass
(if equipped)
Cap
Screw the cap back onto the xture.
1
543
2
  • Page 1 1
  • Page 2 2

Lumination Tela Mini Series Snoot Accessory Installation guide

Lumination
Brand
Lumination
Model
Tela Mini Series Snoot Accessory
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents