Hubbell P600-2804 Assembly Instructions

Brand: Hubbell

Model: P600-2804

Type: Assembly Instructions

Hubbell P600-2804 is a Grounding Simulator Kit that enables users to simulate various grounding scenarios. It includes three wooden bases, spacer tubing, poles with wires and springs, crossarms, conductor rods, primary black leads, white leads, a seven-prong plug, a transformer, a cluster bar, a lineman, and 10 jumpers. By assembling these components, users can create a model of a power distribution system and test different grounding configurations.

POWER SYSTEMS, INC.

1. Set the three wooden bases on a table approximately 2 feet apart.

2. Insert the spacer tubing into the sides of the bases and push together.

3. Into the base on the left, insert the pole with wires and a spring.

Into the center base, insert the pole with the double eye.

Into the base on the right, insert the pole with the spring only.

Orient the poles in the outer bases so the springs point toward the

center base. Make sure the gray end of the pole is on top and the gray

insulators on the sides of the poles point towards the audience.

4. Stretch both springs and connect them to the eye on the center pole.

5.Onto the center pole, install the crossarm that has metal inserts in the

insulators. Be sure the end of the crossarm with the velcro attached

points towards the audience.

6. Install the other two crossarms onto the outside poles, making sure the

phase spacing is identical.

7. Slide the conductor rods through the outer insulators and thread the

rods into the inserts in the center pole insulators.

8. Attach the three primary black leads to the ends of the conductors.

Attach the upper neutral white lead to the neutral conductor. Attach

each of the three white leads from the transformer to a hole near the

bottom of the three poles.

9. Push the seven-prong plug into the transformer.

10. Mount the cluster bar on the center pole approximately 3 inches below

the neutral.

11. On the center pole crossarm, attach the lineman with the light towards

the audience, using the velcro.

Grounding Simulator Kit

Catalog No. C600-1950

Assembly Instructions

NOTE: Because Hubbell has a policy of continuous product improvement, we reserve the right

to change design and specifications without notice.

1998 Hubbell/Chance, 210 N. Allen St., Centralia, MO 65240 USA

Printed in USA

P600-2804

Conductors

Neutral

Conductor

Pole

with Wiring

and Spring

Seven-Prong

Plug

Note: The holes in the poles above and

below the neutral are for attaching one lead

of the man to the pole to simulate a man

standing on the pole.

Transformer

10 Jumpers

Spacer

Tubing

Base

Spring

Cluster

Bar

Pole

with

Double-Eye

Pole

with Spring

Insulators

Crossarm

Lineman

Crossarm

with Threaded Inserts

in Insulators

Insulator

Neutral Conductor

Conductors

Hubbell P600-2804 Assembly Instructions

Hubbell P600-2804 Assembly Instructions

Hubbell P600-2804 Assembly Instructions

Related papers

Other documents