2. Hubbell Wiring Device-Kellems
  3. PD2826

Hubbell Wiring Device-Kellems PD2826 Installation guide

  • I've reviewed the installation instructions for the Hubbell Inline Connector HBL20SPM. This document provides detailed steps on how to prepare and connect wires, along with torque specifications for the screws. I can answer your questions about wire compatibility, installation process, and the use of strain relief inserts.
  • What is the recommended strip length for the outer jacket?
    What is the recommended strip length for the conductors?
    What is the required torque for the terminal screws?
    What is the recommended torque for mounting screws?
Catalog Number: Male Inline HBL20SPM Hubbell
20A/125V - 15A/250V
Use with 16/3 type SJO, 0.34” nom. through 12/3 type
SO, 0.62” nom. Remove outer jacket 1-5/8” strip
conductors 3/8” (DO NOT TIN).
Place wire shoe over all loose wire strands of each
conductor.
Insert wires into barrel of terminal (green wire in middle
terminal) torque screws to 12 in-lbs.
Install strain relief inserts if required.
Attach cover and secure with (3) mounting screws – 12
in-lbs torque.
Cord holding system has six (6) different combinations
offering openings from 0.50” to 0.60”. Typical uses are
depicted below.
12/3 SO
No Inserts
12/3 SJOW
Two Inserts
Max. Clearance
14/3 SF2 with glass
Sleeve, two inserts
Max. clearance
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
1-800-288-6000
Shelton, CT 06484
www.hubbell-wiring.com
PD2826 09/17
/