GOLDMUND Metis Tower Active Wireless – 6
3 SELECTING THE SPEAKER LOCATION
To achieve optimal performance, please observe the following points:
• The Metis Tower Active Speakers and the USB dongle should be placed in the same room.
• There should be no metallic obstacles between the USB dongle and the Metis Tower Active
Speakers, which could influence the wireless link.
• The computer with the USB dongle should not be moved around during playback.
Wireless audio link range:
The range of the wireless audio link depends on several factors, such as the amount of WiFi
equipment used in proximity of the Metis Tower Active Speaker system, as well as the building
materials and the architecture of the room.
Depending on the above mentioned factors, the maximum range will normally be from 5 to 20 meters.
4 CONNECTING THE METIS TOWER
To use the Metis Tower follow these steps:
• Position the left and right speakers according to the serial number labels indicating the
channel located on the back side of each speaker. The speaker with the label L should be on
the left and the one with the label R on the right.
• Screw the antenna on the back side of each speaker.
• Connect the speakers to a mains outlet using the power cords contained in the box.
• Connect the USB dongle to a USB port on your computer.
• In your computer’s audio settings, select the USB dongle as the audio output.
The system is now set up and ready to be used. The volume is set directly on the computer.
ATTENTION
Due to the high gain of the Metis
Tower Wireless speaker, please make
sure that the media player is set to a
low output level, before connecting the
dongle to the computer.