I
I
r
r
D
D
A
A
®
®
C
C
o
o
m
m
p
p
l
l
i
i
a
a
n
n
t
t
P
P
r
r
o
o
t
t
o
o
c
c
o
o
l
l
P
P
r
r
o
o
c
c
e
e
s
s
s
s
o
o
r
r
921 Corporate Way, CA 94539
Tel: +1-510-490-8024, Fax: +1-510-623-7268
E-mail: [email protected], http://www.actisys.com
A
A
A
C
C
C
T
T
T
-
-
-
I
I
I
R
R
R
8
8
8
2
2
2
0
0
0
0
0
0
P
P
P
/
/
/
P
P
P
M
M
M
¾ A complete IrDA
®
Protocol stack in a single chip.
¾ Includes IrPHY
TM
encoding/decoding and interfaces directly to Infrared transceivers
for data rate up to 115.2 kbps. Only an external Infrared transceiver is needed to
complete an IrDA compliant infrared communication subsystem.
¾ Off-the-shelf, semi-custom, or full-custom firmware in on-chip Flash EPROM.
¾ Supports both IrDA Primary and Secondary mode.
¾ Supports host baud rate from 9.6 kbps to 115.2 kbps.
¾ Low supply voltage, 3.0 V to 3.6 V.
¾ Low current consumption, 2μA standby, 3mA active.
¾ Small low profile plastic 64-pin QFP package.
¾ Choice of different amount of on-chip RAM and Flash EPROM to optimize cost and
performance.
¾ Available in programmed and tested chips, assembled & tested boards, or fully
packaged devices.
¾ Abundant uncommitted on-chip resources can be utilized to implement a small
complete embedded system by itself without a host CPU.
¾ A ready-made IrDA-compatible CMOS board and RS232 dongle for SCI interface are
available: UART board: ACT-IR100Spi ; RS232 dongle: ACT-IR100SP
¾ A very useful Evaluation Kit Full Set is ACT-IR8200PEKK, which is: ACT-IR8200PEK
+ ACT-IR4000US (notebook/desktop USB-IrDA adapter). This is to test
ACT-IR8200P with ACT-IR4000US in the earlier developing stage to avoid debugging
multiple issues at the same time.
All trademarks, logos, organization & company names, and product model names are owned by the
respective organizations or companies
/
