INSTALLATION AND SAFETY INSTRUCTIONS
1. Strip 1/4" from end of power source wires (Not supplied).
2. Split about 3/4" and strip 1/4" from end of Ambiance™ low
voltage cable (Not supplied).
3. Remove terminal block inserts from housing (if applicable).
4. Place striped ends of wires into terminal block inserts
making sure all bare wires are inside and tighten with
screws.
5. Snap terminal block inserts with attached wires into the
housing.
6. Place cover over the housing and secure both to the
surface with long screw provided
NOTE:
For Hard Surfaces:
Secure housing to the surface with double faced tape. Place
cover over the housing and secure with shorter screw
provided.
7. Secure track (not supplied) to surface with screws or
double faced tape (not supplied) making sure the end of
track is touching the cover of the splicer
.
FOR YOUR SAFETY HC-434
HC-434
112006
WARNING: Be sure the electricity to the wires you are work-
ing on is shut off; either the fuse removed or the circuit
breaker off.
Warning: Use of other manufactures components will void
warranty, listing and create a potential safety hazard.
WARNING-RISK OF SHOCK. 24V SYSTEM NOT SUITABLE
FOR OUTDOOR USE.
SCREW
COVER
TERMINAL
BLOCK
INSERT
TERMINAL
SCREW
*NOT SUPPLIED
FIGURE 1
*LOW
VOLTAGE
CABLE
HOUSING
*POWER
SOURCE
WIRES
INSTALLATION AND SAFETY INSTRUCTIONS
1. Strip 1/4" from end of power source wires (Not supplied).
2. Split about 3/4" and strip 1/4" from end of Ambiance™ low
voltage cable (Not supplied).
3. Remove terminal block inserts from housing (if applicable).
4. Place striped ends of wires into terminal block inserts
making sure all bare wires are inside and tighten with
screws.
5. Snap terminal block inserts with attached wires into the
housing.
6. Place cover over the housing and secure both to the
surface with long screw provided
NOTE: For Hard Surfaces:
Secure housing to the surface with double faced tape. Place
cover over the housing and secure with shorter screw
provided.
7. Secure track (not supplied) to surface with screws or
double faced tape (not supplied) making sure the end of
track is touching the cover of the splicer.
FOR YOUR SAFETY HC-434
112006
WARNING: Be sure the electricity to the wires you are work-
ing on is shut off; either the fuse removed or the circuit
breaker off.
WARNING-RISK OF SHOCK. 24V SYSTEM NOT SUITABLE
FOR OUTDOOR USE.
HC-434
Warning: Use of other manufactures components will void
warranty, listing and create a potential safety hazard.
SCREW
COVER
TERMINAL
BLOCK
INSERT
TERMINAL
SCREW
*NOT SUPPLIED
FIGURE 1
*LOW
VOLTAGE
CABLE
HOUSING
*POWER
SOURCE
WIRES
-
1
Generation Lighting 9459-15 Installation guide
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
CommScope MFC-12MX-6SP-30-BG Termination Instructions
-
Raymarine C120 Installation guide
-
-
Harman Stove Company PF 100 User manual
-
Furukawa Electric Fusion Splicer S179A User manual
-
Raymarine E120 Installation guide
-
-
3M Scotch® Continuous Taping System Tape 3785 Operating instructions
-
Allied Telesis AT-EN646 User manual
-
Greenlee 910 FS User manual