WEG Enclosure Size 3 IP20 Kit User guide

Enclosure Size 3 IP20 Kit
WEG
Brand
WEG
Model
Enclosure Size 3 IP20 Kit
Type
User guide

This manual is also suitable for

Page is loading ...
2
ENGLISH
Table 1 - Contents of the Kit
1. DESCRIPTION OF THE KIT
Contents:
2. SAFETY NOTICES
DANGER!
Disconnect the supply of the Soft-Starter SSW-07/SSW-08 before installing
the IP20 kit.
3. OPTIONAL MODULE DESCRIPTION
This optional module has the function to protect against contact to energized
parts.
The Enclosure Size 3 IP20 Kit is connected directly to the SSW-07/SSW-08. The
module is xed close to the power terminals, both at the line input and at
output to the motor.
4. ENCLOSURE SIZE 3 IP20 KIT INSTALLATION PROCEDURE
1. Contents of the kit. 2. Fix the bottom cover at the holes
located on both sides of the power
terminals.
SSW-07/SSW-08 Enclosure size 3 IP20 Kit (Part number: 10413866)
Quantity Description
1 Enclosure size 3 IP20 optional kit
3
ENGLISH
4. Press it down until it ts into the bottom
cover.
3. First x the second support on the upper
side.
5. Verify if the supports are connected.
6. To connect the supports of the power
supply, repeat the same sequence.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

WEG Enclosure Size 3 IP20 Kit User guide

Enclosure Size 3 IP20 Kit
WEG
Brand
WEG
Model
Enclosure Size 3 IP20 Kit
Type
User guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents