2. WEG
  3. Enclosure Size 3 IP20 Kit
Enclosure Size 3 IP20 Kit

WEG Enclosure Size 3 IP20 Kit, SSW-07 User guide

  • Hello! I am an AI chatbot trained to assist you with the WEG Enclosure Size 3 IP20 Kit User guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
  • What is the Enclosure size 3 IP20 Kit for?
    What does the Enclosure Size 3 IP20 Kit include?
    Where is the Enclosure Size 3 IP20 Kit installed?
    What safety precautions should be taken before installing the Enclosure Size 3 IP20 Kit?
    What is the purpose of the bottom cover included in the Enclosure Size 3 IP20 Kit?
Page is loading ...
2
ENGLISH
Table 1 - Contents of the Kit
1. DESCRIPTION OF THE KIT
Contents:
2. SAFETY NOTICES
DANGER!
Disconnect the supply of the Soft-Starter SSW-07/SSW-08 before installing
the IP20 kit.
3. OPTIONAL MODULE DESCRIPTION
This optional module has the function to protect against contact to energized
parts.
The Enclosure Size 3 IP20 Kit is connected directly to the SSW-07/SSW-08. The
module is xed close to the power terminals, both at the line input and at
output to the motor.
4. ENCLOSURE SIZE 3 IP20 KIT INSTALLATION PROCEDURE
1. Contents of the kit. 2. Fix the bottom cover at the holes
located on both sides of the power
terminals.
SSW-07/SSW-08 Enclosure size 3 IP20 Kit (Part number: 10413866)
Quantity Description
1 Enclosure size 3 IP20 optional kit
3
ENGLISH
4. Press it down until it ts into the bottom
cover.
3. First x the second support on the upper
side.
5. Verify if the supports are connected.
6. To connect the supports of the power
supply, repeat the same sequence.
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
Page is loading ...
/