Dehumidifier Drain Tube Set Up
The drain tube should have a white
threaded piece on one end. This is
the piece that connects to the
garden hose.
This is the hole that the drain tube
goes into. When not using the drain
tube this hole is plugged with a
rubber stopper.
To set up continous drainage, remove
the rubber stopper and insert the drain
tube into the hole.
Feed the drain tube through, and
from the front of the unit,
connect the drain tube to the
drain spout in the upper left
portion of the water tank cavity.
When the drain tube is fully
inserted, this adapter piece sticks
out. This piece is threaded so that
it can fit a low pressure garden
hose. In the picture the treaded
piece is not screwed in, but you
would screw it in with one screw
at 3 o’clock and one screw at 9
o’clock
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Buell Buell Blast P3 2001 User manual
-
aqua-pure APRO13212 Installation And Operating Instructions Manual
-
Gardena Pond Silt Remover User manual
-
Santerra Green Y60-110V-GREYGRANITE User manual
-
-
DLE Engines DLEG0420 Owner's manual
-
-
-
-
Berkeley 5PNP15H Shallow Well Water System Owner's manual
