American Standard 2425E-LHO User manual

Brand: American Standard

Model: 2425E-LHO

Category: Sanitary ware

Type: User manual

This manual is also suitable for

WILLIAMSBURG ELITE™ 5’ INTEGRAL APRON

WHIRLPOOLS BY AMERICAN STANDARD

HIGH GLOSS ACRYLIC

WILLIAMSBURG ELITE™ 5’ INTEGRAL APRON

WHIRLPOOL

Comfortable bathing design with form-fitted

backrest and molded-in armrests

❏ 2425E-LHO Left Hand Drain Outlet

(specify White 020, Bone 021, or Linen 222)

❏ 2425E-RHO Right Hand Drain Outlet

(specify White 020, Bone 021, or Linen 222)

• Acrylic with fiberglass reinforcement

• Integral apron with removable access panel

• Integral three-sided, tiling / water retention

flange

• 1.5 HP self-draining pump/motor

with dry run seal

• Eight multi-directional and flow adjustable jets

including:

Two high performance Ideal-flow™ Jets

Six interchangeable Flex-jets™

• Two silent air volume controls

• Deck-mounted On/Off control

• Complete factory installed and tested

whirlpool system

❏ 2425EC-LHO Left Hand Drain Outlet

(specify White 020, Bone 021, or Linen 222)

❏ 2425EC-RHO Right Hand Drain Outlet

(specify White 020, Bone 021, or Linen 222)

• Same as above with the StayClean™

whirlpool system featuring Antimicrobial

AlphaSan®

Nominal Dimensions:

60” x 32” x 21-1/2”

(1524 x 813 x 546mm)

HD-016

SPS 2425E-LHO/RHO

Revised 6/03

Compliance Certifications -

Meets or Exceeds the Following Specifications:

• Underwriters Laboratories - Hydromassage

Bathtubs UL 1795

• ASME A112.19.7M for Whirlpool Appliances

• ANSI Z124.1 for Plastic Bathtubs

• ASTM E162 for Flammability

• NFPA 258 for Smoke Density

* See American Standard Faucet Selector

NOTE: Roughing-in dimensions and product

specifications shown on reverse side of page.

Components Needed:

❏ Bath Filler*: (specify finish)

❏ Bath Drain: BATH-DRAIN

(specify Chrome 002, Polished Brass 099,

or Satin 295)

Custom Accessories Available:

❏ Pulse Jet Kit: PULSE-JET (two per kit, specify

White 020, Bone 021, or Linen 222)

❏ Soft Jet Kit: SOFT-JET (two per kit, specify

White 020, Bone 021, or Linen 222)

❏ E-Z-Install™ Whirlpool Heater - EZHEAT-100

NOTE: E-Z-Install™ Whirlpool Heater is designed to

maintain water temperature during operation. It will not

heat cold water to desired bathing temperature.

WILLIAMSBURG ELITE™ 5’ INTEGRAL APRON

WHIRLPOOLS BY AMERICAN STANDARD

HIGH GLOSS ACRYLIC

NOTES:

BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE

INSTALLATION. SUPPORT OF BATH BY SUMP BEDDING. SUPPORT AND ENCLOSING MATERIAL BY OTHERS.

REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.

FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.

PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.

IMPORTANT:

Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1

These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or

voided leaflet.

21-1/4

(540mm)

REF.

DIM

1" WATER

RETENTION

FLANGE

(3 SIDES)

21-1/2

(546mm)

1-1/2 O.D.TAILPIECE

BATH

SUPPORT

MATERIAL

LEVELING STRINGER

NOT FOR SUPPORT

ROUGH

FLOOR

FINISHED

WALL

TOP OF

DECK

(1524mm)

(813mm)

WATER

RETENTION

FLANGE

(3 SIDES)

10-1/4

(260mm)

(305mm)

(76mm)

(8) JETS

3-1/2

(89mm)

CUTOUT IN FLOOR FOR DRAIN

PUMP

FINISHED

WALL

(305mm)

OPT.

OPTIONAL TO

FINISHED FLOOR

USUALLY BETWEEN

65 & 78

(1651 & 1981mm)

C/L OF

OVERFLOW

(102 mm)

C/L OF

SPOUT

TILING

FLANGE

C/L OF

VALVES

C/L OF

SHOWER ARM

2-3/4

(70mm)

4-5/8

(117mm)

1-1/2 N.P.T.M.

THREADS

3/4

(19mm)

(229 mm)

C/L OF

SUPPLIES

C/L OF DRAIN

SEE FITTING

SPECS FOR

DIMENSIONS

(2) AIR VALVES

ON/OFF

SWITCH

ACCESS TO PUMP/MOTOR

THROUGH REMOVABLE

FRONT ACCESS PANEL

UNDERSIDE

OF DECK

(406mm)

IN-LINE HEATER

REMOVABLE

BLANK

GENERAL SPECIFICATIONS FOR 2425E WHIRLPOOL

WHIRLPOOL ELECTRICAL SPECIFICATIONS

PUMP 1.6 HP, 9.7 AMPS,120V.

60 x 32 x 21-1/2 (1524 x 813 x 546mm)

115 Lbs. (52 Kg.)

574 Lbs. (258 Kg.)

55 Gal. (208 L.)

45 Gal. (171 L.)

16-1/4 x 38-1/4 (413 x 972mm)

26-1/4 x 52-1/2 (667 x 1334mm)

15 (381mm)

43 Lbs./Sq.Ft. (208 Kgs./Sq.m)

20.8

35.3

INSTALLED SIZE

WEIGHT

WEIGHT w/WATER

GAL. TO OVERFLOW

WHIRLPOOL MIN. OPERATING VOL.

BATHING WELL AT SUMP

BATHING WELL AT RIM

WATER DEPTH TO OVERFLOW

FLOOR LOADING

(PROJECTED AREA)

PTS.

CUBE (FT

)

American Standard 2425E-LHO User manual

Brand: American Standard

Model: 2425E-LHO

Category: Sanitary ware

Type: User manual

This manual is also suitable for

Download PDF

report

American Standard 2425E-LHO User manual

This manual is also suitable for

American Standard 2425E-LHO User manual

Related papers