2. Anova
  3. ST1010

Anova ST1010 Installation guide

  • Hello! I've analyzed the provided specification sheet for the DOGIPOT POLY Pet Station. This document details the components and installation process for this comprehensive pet waste management solution. It includes instructions for assembling the sign, dispenser, waste receptacle, and mounting post. I'm ready to assist you with any questions regarding this product.
  • What is included in the Poly DOGIPOT Pet Station?
    How high is the Pet Station when fully assembled?
    What is the capacity of the trash receptacle?
DOGIPOT® TELESCOPING POST (ITEM 1301-P)
800.364.7681 www.DOGIPOT.com
SPECIFICATION, INSTALLATION AND OPERATION SHEET
POLY DOGIPOT® PET STATION (ITEM #1010)
Y0UR POLY DOGIPOT® PET STATION INCLUDES:
• PolyDOGIPOT®PetSign,withmountinghardware(two(2)2¼”x¼”bolts,washersandlocknuts)
• PolyDOGIPOT®JuniorBagDispenser(ITEM#1007-2),withmountinghardware(one(1)2¼”x¼”shoulder
 boltandone(1)2½”x¼”bolt,washersandlocknuts)
• Two(2)keysforDispenserbottomlockingaccesstray/insert
• Two(2)rollsofDOGIPOT®SmartLitterPickUpBags™(ITEM#1402)(200countperroll),installed
 inDOGIPOT®JuniorBagDispenser
• 10gallonPolyTrashReceptacle(ITEM#1208-L)withattachablelidwithmountinghardware(two(2)2¾”x¼”
 bolts,washers,fenderwashersandlocknuts)
• One(1)boxDOGIPOT®SmartLinerTrashBags™(ITEM#1404)(50Count)
SEPARATE SHIPPING BOX
• 2”x2” x4’-8’PolyTelescopicMountingPost,withinstallationhardware(two(2)carriagebolts(2½”x5/16”),
washersandlocknuts)
PLEASE CHECK THE ABOVE INVENTORY AND CALL YOUR DISTRIBUTOR IF ANY PARTS ARE MISSING.
INSTALLATION AND OPERATION INSTRUCTIONS
1.SelectagoodvisiblespotinyourcommunityorparkwhereyouwanttoinstallthePolyDOGIPOT®PetStation.
2.Priortoinstallation,removethe1¾”x1¾”x4’portionofthemountingpostfromthe2”x2”x4’portionofthe
mountingpostbeforecementing. Insert the larger portion of the mounting post (2” x 2” x 4’) approximately 14”
into an 18” deep by 8” diameter hole filled with a 40 lb. bag of “ready to use” concrete mix. Tostabilizethepostwhilecementing,placearod,
boltorotherdevicethroughthetwobottomholes,priortoinsertingintothegroundandcementing.Levelthepostinastraightverticalposition
andletconcretedryforatleast12hours.(NOTE: the three holes 1½” apart indicate the top of the 2” portion of the post).
3.Aftertheconcreteisdry,insertthesmallerportionofthepost(1¾”x1¾”x4’)intothelargercementedportionofthepost(2’x2’x4’)untilthe
bottomtwoholesofthe1¾”postarealignedwiththeuppertwoholesofthe2”post. (NOTE: the two holes 1½” apart indicate the bottom of
the 1¾” post).Insertthetwo(2)2½”x5/16”carriageboltsthroughthealignedpostholesfromfronttobackandafxthewashersandlocknuts
toxthetelescopicpostinposition.Thetotalheightabovegroundwithbothpostpartsshouldnowbeapproximately6’6”. (NOTE: the 4th hole
down from the top of the 2” post is for installation of the Poly DOGIPOT® Trash receptacle).
4.StartbyinstallingtheDOGIPOT®PetSignontopofthe1¾”post,withtheupperholematchingthemostupperholeinthesquarepostusing
the enclosed 2½” bolts, washers and locknuts. Continue installing the Poly DOGIPOT® Junior Bag Dispenser according to the mounting
instructions enclosed with the Dispenser, ensuring that the upper edge of the Dispenser is approximately 1” below the lower edge of the
DOGIPOT®PetSign. (NOTE: the 2¼” x ¼” shoulder bolt is to be installed with an exterior washer in the top mounting hole of the Dispenser.
DO NOT OVER-TIGHTEN TO AVOID POSSIBLE CRACKING OF DISPENSER UNIT).
5.InstallthePolyDOGIPOT®TrashReceptaclethroughthepre-drilledholesinthebackwallofthereceptacleandthroughthesquarepostwith
theremainingbolts,washersandlocknuts.ATTACH THE LID TO THE WASTE RECEPTACLE PRIOR TO MOUNTING.Usethe2”fenderwashers
forinstallationontheinsideofthereceptacle.Theupperedgeofthetrashreceptaclemustbeapproximately11.5”belowthelowerendofyour
PolyDOGIPOT®JuniorBagDispenser.Thetrashreceptaclelidwillopentoapre-determinedangletopreventitfrombeingoverextended.The
receptaclelidwillhitthepostwhenitisfullyopened.
6.InsertoneoftheenclosedDOGIPOT®SmartLinerTrashBags™intothetrashreceptacle,foldingitovertheedgeofthereceptacleandclosethe
trashreceptaclelid.
7.ENJOY WATCHING PET OWNERS PICK UP AFTER THEIR DOGS!
DOGIPOT® TELESCOPING POST (ITEM 1301-P)
800.364.7681 www.DOGIPOT.com
(A) DOGIPOT® PET SIGN (ITEM #1203 / 1204)
 •H:18”xW:11.5”
 •14gaugereectivealuminum
 •Weight:1.35lbs.
 •Forestgreenonwhite
(B) POLY DOGIPOT® JUNIOR BAG DISPENSER (ITEM #1007-2)
 •H:17”xW:10”xD:3”
 •2.5mmABS/PPforestgreenpolyethylene
 •Weight:5lbs.
 •400bagcapacity
 •Twodiamondshapedbagdispenserslots
 •Bottomlockingaccesstray/insert
 •Clearlypostedinstructions
(C) POLY TRASH RECEPTACLE WITH LID (ITEM #1208-L)
 •H:21”xW:13”xD:12”
 •2.5mmABS/PPforestgreenpolyethylene
 •Weight:4lbs.
 •10galloncapacity
 •Attachablehingedlid(ITEM#1210-N)
 •One(1)box50count
DOGIPOT®SmartLinerTrashBags™
 (ITEM#1404)included(5lbs.)
(D) TELESCOPIC POLY MOUNTING POST (ITEM #1304)
 •2”x2”x8’
 •.125gaugeberglass
 •Weight:8lbs.
TOTAL HEIGHT FROM ABOVE GROUND:
 •6’.6”
SPACE BETWEEN DISPENSER AND SIGN:
 •1.0”
SPACE BETWEEN RECEPTACLE AND DISPENSER:
 •11.5”
SPACE BETWEEN GROUND AND RECEPTACLE:
 •9.0”
HOLE:
 •D:18.0”xW:8.0”
 •Fillwith40lbs.“readytouse”cement
TOTAL SHIP WEIGHT: 36 LBS.
(MOUNTING HARDWARE INCLUDED)
(B)
(C)
(D)
(A)
SPECIFICATION, INSTALLATION AND OPERATION SHEET
POLY DOGIPOT® PET STATION (ITEM #1010)
/