Hubbell Wiring Device-Kellems PD1859 Installation guide

Type
Installation guide
®
Wiring Device-Kellems
Hubbell Incorporated (Delaware)
185 Plains Road
Milford, CT 06460-8897
(203) 882-4800
PD1859 (Page 1) PRINTED IN USA 10/01
Installation Instructions
Liquid-Tight Flexible
Non-Metallic
Conduit/Tubing Connector
1. CUT CONDUIT/TUBING END SQUARE.
2. APPLY COMPRESSION NUT OVER CONDUIT/TUBING.
3. TAP THE FERRULE ONTO THE END OF THE CONDUIT/TUBING. CONDUIT
SHOULD ENGAGE FERRULE FINGERS ½ MIN. (SEE FIG 4).
4. POSITION SWIVEL ELBOW OR STRAIGHT BODY ONTO FERRULE AND
THREAD COMPRESSION NUT INTO PLACE.
5. HAND TIGHTEN THE COMPRESSION NUT UNTIL SECURELY BOTTOMS OUT
AGAINST THE FERRULE. TO INSURE FULL LIQUID-TIGHT GRIPPING
CAPABILITY, THE GAP BETWEEN THE NUT AND THE BODY FLANGE SHOULD
BE LESS THAN .055 (SEE FIG 3.).
6. SNAP SEALING O-RING ONTO SEAT PROVIDED FOR A LIQUID-TIGHT SEAL
THROUGH ANY BOX APPLICATION.
7. SECURE WITH LOCKNUT OR INTO FEMALE THREAD AS REQUIRED.
LOCKNUT
KNOCKOUT SWIVEL ELBOW
COMPRESSION NUT
SEALING O-RING FERRULE ROTATE INTO POSITION ABOUT
THIS CENTERLINE (INDEXES
EVERY 15 DEGREES)
STRAIGHT BODY
CONDUIT/TUBING
FIG. 1
FIG. 2
FIG. 3
FIG. 4
PD1859 (Page 2) PRINTED IN U.S.A. 10/01
Trade Recommended
Size Min. to Max.
1/2 .859 - .906
3/4 1.094 - 1.141
1 1.359 - 1.406
11/4 1.719 - 1.766
11/2 1.969 - 2.016
2 2.453 - 2.500
Recommended Knockout Holes
LOOK FOR
KELLEMS®
QUALITY PRODUCTS FOR ALL
YOUR WIRE MANAGEMENT NEEDS
Polytuff I - Flexible liquidtight nonmetallic conduit.
Polytuff II - Flexible liquidtight nonmetallic tubing.
Metallic - Insulated and noninsulated for metallic and nonmetallic
Fittings flexible liquidtight conduit.
Nonmetallic - For nonmetallic liquidtight flexible conduit or tubing.
Fittings
  • Page 1 1
  • Page 2 2

Hubbell Wiring Device-Kellems PD1859 Installation guide

Type
Installation guide

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI