Clarke 6500126 Assembly Instructions Manual

Type
Assembly Instructions Manual

This manual is also suitable for

OPERATING & MAINTENANCE
INSTRUCTIONS
WOODEN WORKBENCH
MODEL: CHB1500
Part No. 6500126
ASSEMBLY INSTRUCTIONS
02/07
211
The Completed Workbench
ASSEMBLY
3
INTRODUCTION
Thank you for purchasing this CLARKE Wooden Workbench.
Please read these instructions carefully in order to ensure that the workbench is
assembled correctly, thereby ensuring that it provides you with long and satisfactory
service.
GUARANTEE
This CLARKE product is guaranteed against faulty manufacture for a period of 12 months
from the date of purchase. Please keep your receipt as proof of purchase.
This guarantee is invalid if the product is found to have been abused or tampered with in
any way, or not used for the purpose for which it was intended.
Faulty goods should be returned to their place of purchase, no product can be returned
to us without prior permission.
This guarantee does not effect your statutory rights.
10
ASSEMBLY
Fit the pins and dogs as
required.
K
K
Fit the drawer and clamps
as shown.
4
PACK CONTENTS
A
x2
x1
x1
x1
x2
x1
x1
x2
B
C
D
E
F
G
H
Side pieces
Left leg frame
Right leg frame
Shelf base
Drawer Holder
Workbench
Drawer Front
Drawer Side
9
DRAWER ASSEMBLY
12
34
1. Fit the rear of the drawer (J) to one of
the drawer sides (H) and fix into
position using the hinge and screws
provided.
2. Fit the other side (H) as shown.
3. Rotate the drawer and slide the
drawer base (I) into position.
4. Fix the drawer front (G) as shown
above.
The drawer is now complete.
5
PACK CONTENTS
I
J
K
L
M
N
O
P Q
x1
x1
x2
x4
x4
x4
x4
x8
x8
Drawer base
Drawer rear
Clamp
Workbench dog
Workbench pin
Shelf nut and bolt
Wood Bolt
x4
Washer
8
P
P
P
P
O
OO
O
QQ
Q
Q
E
E
ASSEMBLY
5. Lay the workbench (F)
on it’s top.
6. Place the Legs into
position and secure in
place using Bolts (O)
and Washers (Q).
At this stage the frame
should look like this.
7. Fix the drawer holders
(E) into place using the
four long wood screws
(P) supplied.
Make sure that the dowel
pins on the drawer holders
are positioned towards the
front of the workbench.
6
ASSEMBLY
A
A
NN
N
N
A
B
N
Q
N
Q
C
1. Insert the nuts from
part (N) into the side
pieces (A).
2. Use the Bolts (N) and
Washers (Q) to secure
both leg frames (B and
C) to one of the side
pieces.
At this stage the frame
should look like this.
7
ASSEMBLY
A
B
C
D
Q
N
Q
N
3. Slide the shelf base (D)
into the grooves as
shown.
At this stage the frame
should look like this.
4. Secure the second
side piece to the two
leg frames using Bolts
(N) and Washers (Q).
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

Clarke 6500126 Assembly Instructions Manual

Type
Assembly Instructions Manual
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI