MODONA 8024D-SN Installation guide

8024D : 24" Double Towel Bar - Square Series

Dimensions:

Installation:

1. Use included TEMPLATE to mark screw positions and a LEVEL to make sure the positions are level.

2. Use a DRILL to drill the holes for the screw anchors (1). Please note that BOTH Regular screw anchors AND

Drywall screw anchors are included, depending on the surface for installation. For the Regular screw anchors

use a 1/4" drill bit. For Drywall screw anchors usa a 3/8" drill bit.

3. Insert screw anchors (1) flush to wall surface.

4. Attach Brakets (2) to wall by affixing screws, making sure lip tilts up AWAY from wall.

5. Attach unit by TILTING top towards wall so that it catches top lip of Brackets. Bring unit FLUSH to wall surface.

6. Use included Allan Wrench (5) to tighten the Tightening Screws (4) located on the bottom of the base until base

is secure and tightly fastened to wall. If base does not fit perfectly flush to wall, please LOOSEN Tightening

Screws first until flush with wall.

For Installation directly to Wood Stud or Wood Surface, omit steps 2 and 3 above.

24"

2 1/4"

26 1/4"

This manual is also suitable for

Download PDF