NIGHT OWL IH8 Series Owner's manual

NIGHT OWL
Brand
NIGHT OWL
Model
IH8 Series
Category
Security camera accessories
Type
Owner's manual

This manual is also suitable for

Adding a Camera to the NVR
Adding a Wired Camera to the NVR
Quick Setup Guide
Optional Step
1
2
Before you get started, you will need:
Cameras / Accessories
1: Optional Step
2 3
Items Not Included
DISCLAIMER: The exact components of your
product, images, and quantities may vary
depending on your model number.
NOTE: Cameras can be powered by Ethernet cables or a
power adapter. Camera power adapter not included.
NOTE: Make sure Ethernet cable is securely connected.
Mounting Hardware
(1 packet per camera)
Dome Camera(s)
Waterproof Cable Cover(s)
(1 per camera)
Bullet Camera(s)
A
B
Hex Key
(May or may NOT
be included)
Ethernet Cable(s) Power Drill
Adding a Wired Camera to the NVR
STOP: BEFORE installing, test each camera locally to
confirm they function properly.
Insert one end of the Ethernet cable into the cable
cover as shown in the image above.
Connect the covered end of the Ethernet cable to the
camera’s power cable.
Insert the other end of the Ethernet cable into an open
Ethernet port on the back of the NVR.
ETHERNET
ETHERNET
WATERPROOF CABLE
COVER
ETHERNET
CABLE
ETHERNET CABLE WITH COVER
COMPLETION
CAMERA CABLE
Camera Installation
1
FOR DOME CAMERA: Remove the mounting base
using the hex key.
HEX KEY
2
Using the holes in the mounting base or the cameras
mounting bracket , mark your screw positions on the
surface where you plan to mount the camera.
AA
3
Using a drill bit slightly smaller than the included
screw anchors, drill into the mounting surface using
the guide marks. Insert the screw anchors. Line up the
camera base holes with the screw anchors. Holding
the mounting base or mounting bracket in place,
insert screws and tighten until secure.
If your Ethernet cable is not being run through a wall / ceiling,
use the cut out on the mounting base/bracket.
A
B
B
NOTE: Please ensure you mount the camera
at least 7 ft. above the ground and angle it
slightly down for optimal recording.
A
B
A
B
4
Once mounted, use the hex key to adjust the camera
angle. Turn the hex key counter-clockwise to loosen
and clockwise to tighten. Lefty loosey, righty tighty!
HEX KEY
5
7
FOR DOME CAMERA: If your Ethernet cable is being
run through a wall / ceiling, insert the cable through
the center ring of the mounting base before
mounting. Cable not being run through a wall / ceiling?
Use the cut out .
Once mounted, connect the camera to the NVR.
REV 190801 QSG-CMNVRCON
6
FOR DOME CAMERA: Make sure screws are securely
fastened. Using the hex key, attach the camera to the
mounting base.
www.NightOwlSP.com
2
1
2
1
HEX KEY
  • Page 1 1
  • Page 2 2

NIGHT OWL IH8 Series Owner's manual

NIGHT OWL
Brand
NIGHT OWL
Model
IH8 Series
Category
Security camera accessories
Type
Owner's manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents