Sharkoon 4044951011445 User manual

www.sharkoon.com

SATA QUICKPORT INTERN 4-BAY/6-BAY Manual

Short manual:

1. Switch off your PC and disconnect the power cord.

2. Remove both side panels from your PC case.

3. Take the mounting rail(s) out of the docking station.

4. Use the included ﬁne thread screws to attach the HDD(s)/SSD(s) to the

mounting rail(s) (HDD/SSD connector pointing backwards).

5. Slide the mounting rail(s) back into the docking station.

6. Remove the 5.25" mounting bays’ front bezel.

7. Slide the docking station into the mounting bay.

8. Attach the docking station from both sides inside the mounting bay using

the included coarse thread screws.

9. Connect the docking station’s SATA data cables to the respective SATA

connectors on the mainboard (for further information also refer to your

mainboard’s manual).

10. Connect the power connectors on the docking station’s back side to the

matching power connectors of your PSU.

Note:

Before using the hard disk drive for the ﬁrst time, it must be properly partitioned

and formatted.

Format the HDD by right-clicking COMPUTER and then selecting MANAGE. Under

Windows 7 select START, then right-click COMPUTER and then select MANAGE.

After that, select DISK MANAGEMENT. Here all formatable HDDs and drives will be

clearly displayed. Right-click the USB HDD and select PARTITION. The HDD will

probably need to be initialized, we suggest using the NTFS data system for Win-

dows PCs. Format the HDD to complete the procedure.

Make sure to select the correct hard disk drive for formatting due to all data

saved on the HDD being lost when partitioning and formatting!

Download PDF