2. BLOTZ
  3. B10-ME-007

BLOTZ B10-ME-007, B10_ME_007 Assembly Instructions

  • Hello! I've reviewed the instructions for the BLOTZ Building model Middle East 10mm #7 and am ready to assist you. This document details the assembly process, highlighting the use of PVA glue, sandpaper, and modeling knife. It also advises on using pegs or elastic bands during assembly. Feel free to ask any questions about constructing this model.
  • What type of glue is required?
    What tools are needed for assembly?
    Can I use pegs or elastic bands?
10mm Middle East #7
B10-ME-007
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and
remember to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place
while you allow glue to dry.
Remove the front and back walls of the building
plus the roof piece from the sprue.
Glue the roof section to the walls as shown – note the
position of the hatch.
Take the side walls.
Glue these to the building as shown.
Attach the building to its base.
Take the two stepped pieces, end wall and side wall
from the sprue.
Put then end wall into postion, then glue the two
stepped pieces in place.
Add the front wall.
/