Vertically Driven Products 31550 Installation guide

  • Hello! I've reviewed the installation instructions for the Vertically Driven Products Bumper Cap 31550. This document provides a step-by-step guide on how to install these stubby bumper caps on a Jeep Wrangler JK (2007-2011). The instructions include measurement guidelines, cutting instructions, and how to secure the caps using black pins. I'm ready to answer any questions you have about this installation process, or the product itself.
  • What tools are required for installation?
    How do I measure for the cut?
    What is included in the parts list?
    Are the caps different for each side?
STUBBY JEEP WRANGLER FRONT BUMPER CAPS
PART # 31550 - 2007-2011 JK WRANGLER
Tools Required Parts List
We recommend a professional do your installation if you are NOT familiar Reciprocating Saw (1) Driver Side Cap
with using any of the Tools Required. Tape Measure (1) Passenger Side Cap
Drill Motor (10) Black Pins
Please read instructions before beginning installation. 1/4" Drill Bit
Be sure you have all tools required before you begin.
NOTE: Park vehicle on a level surface
1) Measure 3 1/2" from the Bumper Pad toward the outside
of the bumper both on the top off the bumper and the front of
the bumper and mark with tape
Top Bumper - Measure 3 1/2" from the Bottom of the Tapered
Edge of the Bumper Pad
Bumper Pad
Front Bumper - Measure 3 1/2" from the Bottom of the Tapered
Edge of the Bumper Pad
NOTE: The 3 1/2" is not a precise measurement - You can be a Tad Off
Bumper Pad 3.5" Measure 3.5" from the Bottom
of th Tapered Edge toward the
Bottom of Tapered Edge Outside of the Bumper
3 1/2" Lookig Down Top Bumper OutSide Bumper
2) Using a Reciprocating Saw cut along the INSIDE edge of the tape
line where you measured at the 3 1/2" Mark
NOTE: You will be cutting
through both the plastic
and metal portions of
the bumper
INSIDE EDGE
3) Place the caps on the bumper - Make sure they are aligned
properly on the bumper (Fig. 5)
NOTE: There is a Drivers Side and Passenger Side
(Caps are marked on the bottom)
Shown installing on the Drivers Side
STUBBY JEEP WRANGLER FRONT BUMPER CAPS
PART # 31550 - 2007-2011 JK WRANGLER
Instructions Continued from the Front.
4) Using a 1/4" Drill Bit - Drill the installation holes using the Five
(5) pre-drilled holes in the Bumper Cap as a guide
NOTE: There are (5) Pre-Drilled Holes on each Bumper Cap
(2) on Top & (2) on Front & (1) on Bottom of Cap
Pre- Drilled Holes
5) With the Holes aligned - Install the Black Plastic Pin Plugs
pushing through the Bumper Cap into the holes in the bumper.
You are now complete and the Bumper Cap is Installed.
REPEAT STEPS 1 through 5 FOR INSTALLING CAP ON OPPOSITE SIDE
REPEAT STEPS 1 though 5 FOR INSTALLING CAP ON THE OPPOSITE SIDE
INSTALLED Passenger Side 10 Plastic Pin Plugs Driver Side
Vertically Driven Products - 1401 Freeman Ave. - Long Beach, CA 90804 (562) 438-5112 [email protected] Oct. 2010 BS
/