INST 00226 140
2016 PORTER ATHLETIC, INC. ALL RIGHTS RESERVED. 4/18/2019
C. Apply Loctite® to threads of pulley set screw and tighten set screw into pulley.
D. Install cogged v-belt onto pulleys; this is best done by wrapping belt around 2” pulley, then feeding it onto 9” pulley while
turning the pulley by hand.
E. Adjust the v-belt tension roller such that the v-belt has enough tension that it will not slip during operation, but do not over
tension the v-belt.
F. Apply Loctite® to threads of ¼-20 hex head screw. Install fender washer, lock washer, and screw into gearbox shaft as
shown to the above right.
G. Proceed with installation of winch following instruction manual included in package (INST00226130).
601 Mercury Drive, Champaign, IL U.S.A. 61822
www.porterathletic.com
(888) 277-7778
THIS WARNING IS GIVEN IN COMPLIANCE
WITH CALIFORNIA’S PROPOSITION 65:
WARNING
This product contains chemicals known to the
State of California to cause cancer, birth defects
or other reproductive harm.
SAVE THESE INSTRUCTIONS FOR FUTURE USE