Clover CCM636 Installation guide

Brand
Clover
Model
CCM636
Type
Installation guide

This manual is also suitable for

INSTALLTION
1. Attach the Mounting bracket to the wall or
ceiling, wherever you want to install the camera.
Locate a wall stud or ceiling joist and secure
the bracket, using the supplied screws.
2. Install the camera to the Mounting bracket
and firmly tighten the swivel.
3. Connect the AC adapter to the DC
jack of the camera and into the 120V
AC outlet.(optional)
TROUBLE SHOOTING
If the system does not function Properly, check the following points
before contacting the service center
HOW TO OBTAIN FACTORY SERVICE
1. Original purchaser must fill out a warranty card and mail to Clover
Electronics USA with model number, serial number and date of purchase.
2. Please pack unit carefully and safely, and sent it prepaid and insured parcel
post to 1307 East 166th Street, Cerritos, CA 90703.
Please include a note stating how the unit is defective.
3. If the unit is returned within the warranty period, include a
proof of purchase and check for $15.00 to cover the cost of return
postage and handling. If the unit is out of warranty, please include a check for
$15.00 to cover the cost of return postage and handing. An estimate of the repair
cost will be sent for your approval.
4.Clover will repair or replace and return to owner all units under this limited
warranty.
LIMITED 2 YEAR WAEEANTY
This warranty gives the original purchaser specific legal rights and you may
have other rights which vary from state to state.
If Clover products do not function because of any defect in material or parts
workmanship. Clover will repair free for a period of 2 years on parts & labor
from the date of original purchase. This warranty does not cover incidental
or consequential damages unless the state of owner’s residence specifically
prohibits limitations on incidental or consequential damages.
TROUBLES
CAUSE & REMEDIES
NO power (no picture / sound)
Picture flickering
Normal sound, dim picture
Picture too bright, too dark
Picture rolls and jumps
Scrambled picture
Picture smaller than screen
or volume weak
AC adaptor not plugged in.
Check the DC,audio, video cables
between the Camera and Monitor
Strong spotlight in the field of view
Improper brightness control on;
Setting on your TV/ Monitor
Lighting source in the field of view
Improper Vertical hold control setting
on your TV/monitor
House current may be too low
U
U
U
U
U
U
U
U
U
U
U
U
U
ྙ
ྙ
ྚ
ྛ
ྜ
ྜྷ
ྚ
ྛ
ྜ
ྜྷ
-
-
Bracket
Screw
Camera
Swivel
AC Adapter
Available Accessories:
CM625
CM625P
CM626
CCM630
CCM630P
CCM636
USER’ S
INSTRUCTIONS
Video Camera for your personal
SAFETY and workplace SECURITY
TO THE USER’S OF
CLOVER CAMERAS
IMPORTANT SAFETY PRECAUTIONS
To prevent fire or shock hazard, do not
expose this product to rain or moisture.
Do not use near a bath tub, wash bowl,
sink, or laundry tub; do not use in a wet
basement or in or around a swimming pool.
To avoid electrical shock, do not open the case
of this product.
Operate this product using only the AC power
supply DC12V 200mA to 250mA.
Do not overload electrical outlets or extension
cords as this can result in fire of electric shock.
Refer servicing to qualified personnel only.
CONNECTIONS
.
.
.
.
.
.
Quility Price Service Synergy
ELECTRONICS U.S.A.
562.282.5700
Quility Price Service Synergy
www.cloverusa.com
CAMERA
CAMERA
AUDIO
VIDEO
TV
VCR
MONITOR
DC JACK
WHITE
YELLOW
RED
RED
AUDIO
VIDEO
TV
VCR
MONITOR
DC JACK
(Audio Version)
(Video Only)
YELLOW
ELECTRONICS U.S.A.
ADT120250 Power Adapter
MBK001 Mounting Bracket
CA030Y(M) 30’ RCA Extension Cable
CA060Y(M) 60’ RCA Extension Cable
CA100Y(M) 100’ RCA Extension Cable
  • Page 1 1
  • Page 2 2

Clover CCM636 Installation guide

Brand
Clover
Model
CCM636
Type
Installation guide
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents