Moneual 902 Ali User manual

Type
User manual
Moneual 902 Ali
User Guide
©2008 Moneual Lab Corporation
2
Please read the following safety information carefully before starting the system.
AC Power Safety Warning
The power supply is pre-set for the country/region in which you purchase the system. If you
move to another country/region, please make sure you check its voltage requirements before
plugging the system into an AC power outlet.
We recommend you use a power surge device. Do not use an extension cord.
For your safety, the power cord provided with your system has a ground plug. Always use the
power cord with a properly grounded wall outlet to avoid the risk of electrical shock.
Checking the Voltage Selection
CAUTION
Setting the voltage selection switch on the wrong voltage may damage the system.
Make sure this switch is set correctly for your location before turning the system on.
A power supply is integrated into the system to provide power to the system. The power
selection switch on the system rear panel can be used to set the power supply to operate at
115V or 230V. Slide the voltage selection switch to the correct voltage position:
• North America typically uses 115V.
• Europe typically uses 230V.
To verify that the system has the correct setting for your environment, check the voltage
selection.
BEFORE YOU BEGIN
Moneual 902 Ali User Guide 3
115V
230V
115V
BEFORE YOU BEGIN
AC Power Safety Warning
Checking the Voltage Selection
ELECTRICAL SAFETY
Operation Safety
Conventions Used in this Manual
BOX CONTENTS
GETTING FAMILIAR WITH THE SYSTEM
Front Panel
Back Panel
SETTING UP THE SYSTEM
Checklist to Set up the System
1. Select the Correct Voltage Selection for Your Area
AC Power Safety warning
Checking the Voltage Selection
2. Set the System in a Well Ventilated Area
3. Connect Video Output
4. Connect Wireless Keyboard
5. Connect Audio
Option 1: 5.1 Analog Audio Connection
Option 2: 7.1 Analog Audio Connection
Option 3: 2-Channel Audio Connection
6. Connect to Internet
7. Connect Power
8. Connect TV Input
9. Verify Audio Settings with Realtek HD Audio Manger
10 Open Windows Media Center
11. Data Loss Disclaimer
12. Limited Warranties
TABLE OF CONTENTS
3
3
3
4
4
4
6
7
7
8
10
10
10
10
10
10
11
12
12
12
13
13
14
15
16
17
18
19
19
Moneual 902 Ali User Guide 5
CAUTION
Proper ventilation is required to keep the system from overheating. Do not block
system vents or place devices directly on top of the system. If placed in a cabinet,
make sure that there is enough ventilation space behind and in front of the system.
Place the system at the bottom of the cabinet.
To prevent electrical shock, disconnect the power cord from the electrical outlet before
relocating the system.
If the power supply is broken, please consult a qualified service technician or your retailer
to avoid electrical shock hazards.
Operation Safety
Make sure that all chords are intact and correctly connected before using this product. Any
detected damage should be reported to your dealer immediately.
To avoid short circuits, keep paper clips, screws, and staples away from connectors, slots,
sockets, and circuitry.
Avoid dust, humidity, and temperature extremes. Do not place the product in any area
where it may become wet. Place the product on a stable surface.
Contact a qualified service technician or your retailer for any technical problems with the
product.
Slots and openings are provided for ventilation; to ensure reliable operation of the product
and to protect it from overheating. These openings must not be blocked or covered. This
product should never be placed near or over a radiator or heat register.
Conventions Used in this Manual
The Caution box indicates information to prevent damage to
components during the attempt to complete a task.
NOTE The Note sign indicates important information.
* Other names and brands may be claimed as the property of others.
ELECTRICAL SAFETY
4
CAUTION
Front Panel
GETTING FAMILIAR WITH THE SYSTEM
Name
Item Description Purpose
1 Power Button Turn on / off the system
2 MIC To connect MIC
3 Headset To connect headset
4 IEEE 1394 To connect IEEE 1394 devices
5 USB To connect USB devices
6 Display window To display MCE status
7 Disc open / close To open or close
8 Multimedia card reader To read/write multimedia card
Item
BOX CONTENTS
Moneual 902 Ali System
Wireless keyboard
Remote control with batteries
Driver CD
OS CD
Power Cord
Motherboard Manual
User Guide
Motherboard
Manual
User Guide
AAA
AAA
Moneual 902 Ali User Guide 76
ᐭᐰᐮᐯ
Back Panel
8
ᐭᐴ
Item Description Purpose
1 Power Switch To turn on Power Supply
2 AC power connector Power Connector
3 Keyboard To connect a PS/2 keyboard
4 Coaxial S/PDIF To connect an external audio device
5 LAN To connect Local Area Network
6 IEEE 1394 To connect a IEEE 1394 device
7 Cen./Sub. To connect the center and subwoofer in the
5.1-channel or regular 2-channel audio system
8 Line In To connect the line out from external audio sources
9 VGA To connect monitor input
10 Voltage selector Voltage selection switch
11 USB To connect a USB device such as scanner,
digital speaker, mouse, keyboard,
hub, digital camera, joystick etc.
12 Optical S/PDIF To connect an external audio device
13 External SATA port To connect an external SATA hard disk drive
14 S.L./S.R. To connect the side left and side right in the
7.1-channel
15 Mic in To connect to the plug from external microphone
16 R.L./R.R. To connect the rear left and rear right in the
5.1-channel
17 Line Out To connect the front left and front right channel in the
5.1-channel or regular 2-channel audio system
Moneual 902 Ali User Guide 9
ᐮᐱᐯᐲ
16
ᐰᐳ
ᐶᐹ
ᐷᐷ
17
Checklist to Set up the System
Use the following checklist as a guide for setting up your system:
[ ] Step 1: Select the correct voltage selection for your area
[ ] Step 2: Place the system in a well ventilated area
[ ] Step 3: Connect video output
[ ] Step 4: Connect wireless keyboard
[ ] Step 5: Connect audio
[ ] Step 6: Connect to Internet
[ ] Step 7: Power on the system
[ ] Step 8: Connect TV Input
[ ] Step 9: Confirm audio setting
[ ] Step 10: Open Windows Media Center
1 Select the Correct Voltage Selection for Your Area
AC Power Safety warning
The power supply is pre-set for the country/region in which you purchased the system, If you
move to another country/region, please make sure you check its voltage requirements before
plugging the system into an AC power outlet.
We recommend you use a power surge protector. Do not use an extension cord.
For your safety, the power cord provided with your system has a grounded plug. Always use
the power cord with a properly grounded wall outlet to avoid the risk of electrical shock.
Checking the Voltage Selection
CAUTION
Setting the voltage selection switch on the wrong voltage may damage the system.
Make sure this switch is set correctly for your location before turning the system on.
See Checking the Voltage section for details on how to set the voltage selection to the proper
setting for your area.
2 Place The System in a Well Ventilated Area
The system must be placed about 12in/30cm away from a wall. Do not block system vents
and do not place a device directly on top of the system. If placed in a cabinet, make sure
there is a 3in/8cm ventilation space behind and in front of the system. Place the system at
the bottom of the cabinet.
SETTING UP THE SYSTEM
3 Connect Video Output
The system needs to be connected to a video display device. You can connect either a HDTV
or a PC monitor.
VGA Connection
VGA cable
(not included)
HDMI cable
(not included)
DVI to HDMI adapter
(included)
OR
High-resolution display TV PC Monitor
Moneual 902 Ali User Guide 11
10
4 Connect Wireless Keyboard
Plug the USB receiver of the wireless keyboard into the USB port at the front or rear panel
of the system. A USB extension cable can be used to connect the USB receiver.
1. Insert the keyboard batteries.
2. Press the connect button on the USB receiver.
3. Press the on/off button on the front side of keyboard.
4. Press the "Connect" key located under the keyboard.
If the keyboard does not work suddenly, press the trackball of the keyboard or reset by
pressing the “Connect” key.
Option 2: 7.1 Analog Audio Connection
Option 3: 2-Channel Audio Connection
5 Connect Audio
This section shows you how to connect the audio system in your home to the HTPC system.
For audio setup, choose one of the options listed below:
Option 1: 5.1 Analog Audio Connection
Option 2: 7.1 Analog Audio Connection
Option 3: 2-Channel Audio Connection
NOTE After setting up the system, use the audio setting application to optimize your
audio settings.
Option 1: 5.1 Analog Audio Connection
Left/right audio cable
(Additional cables not included)
Speakers
7.1 Surround sound receiver
AUDIO INPUTS
FRONT
L
R
SUB
CENTER
SURROUND
L
R
SURROUND
BACK
L
R
Speakers
OR
Left/right audio cable
L
R
AUDIO INPUT
AUDIO INPUTS
FRONT
L
R
SUB
CENTER
SURROUND
L
R
SURROUND
BACK
L
R
7.1 Channel
Left/right audio cable
(Additional cables not included)
Moneual 902 Ali User Guide 13
12
2 Channel
5.1 Channel
Speakers
5.1 Surround sound receiver
S
URROUN
D
L
R
Slide the voltage selection switch to the correct voltage position.
Do the following to turn on the connected devices:
1. Use the power cord to connect the system to a grounded AC outlet. It is recommended
that you use a power surge protector.
2. Press the Power On button on the front of the system.
3. Press the Power On button on the PC monitor.
4. Press the Power On button on the audio system.
6 Connect to Internet
Ethernet LAN cable
7 Connect Power
CAUTION
Setting the voltage selection switch on the wrong voltage may damage the system.
Make sure this switch is set correctly for your location before turning the system on.
North America typically uses 115V. Europe typically uses 230V.
High-speed Internet modem or home network router
RJ-45 Ethernet cable
(not included)
LAN/USB2.0
Moneual 902 Ali User Guide 15
14
Power cord
Surge protector
(recommended)
115V
230V
115V
9 Verify Audio Settings with Realtek HD Audio Manager
Realtek HD Audio Manager is a conversion and refinement tool that affects all audio in the
system regardless of application.
To configure Realtek HD Audio Manager Settings:
1. Go to ‘Control Panel ► Hardware and Sound ►’
2. Select ‘Sound’
3. For HDMI audio setting, select ‘Digital Output Device(HDMI)’ then click ‘Set Default’
Moneual 902 Ali User Guide 17
16
Coaxial cable (Cable TV Provider)
CableCARD
(not included)
Coaxial cable
(Antenna)
8 Connect TV Input
This section shows you how to connect TV input to the HTPC system.
NOTE
Please contact your Cable TV provider regarding CableCARD.
11 Data Loss Disclaimer
Before sending the system out for service, be sure to backup all data and remove all
third party software.
With respect to all service provided, it is your responsibility to backup the contents of your
system, including any data you have stored or software you have installed. It is likely that the
contents of your PC will be lost in the course of service and we will not be responsible for any
damage to or loss of any programs, data or other information stored on any part of any
product serviced hereunder.
IF DURING THE REPAIR OF THE PRODUCT THE CONTENTS OF THE PC ARE ALTERED,
DELETED, OR IN ANY WAY MODIFIED, WE WILL NOT BE HELD RESPONSIBLE. YOUR PRODUCT
WILL BE RETURNED TO YOU CONFIGURED AS ORIGINALLY PURCHASED (SUBJECT TO AVAIL-
ABILITY OF SOFTWARE).
Be sure to remove all third party hardware, software, features, parts, options, alterations, and
attachments not warranted by us prior to sending the product to us for service. We are not
liable for any loss or damage to these items.
12 Limited Warranties
Moneual Lab-branded hardware products purchased in the U.S. come with a 1-year limited
warranty. This limited warranty covers defects in materials and workmanship in hardware
products.
The span of one year for this limited warranty starts on the date of purchase. A receipt
indicating the date of purchase will be required to receive warranty services during this time.
Moneual Lab may change the availability of limited warranties at its discretion, but changes
will not be retroactive.
Contact
Customer Service [email protected]
1-877-450-0105
Moneual 902 Ali User Guide
18
19
10 Open Windows Media Center
If a remote control came with your computer, press the Green Start button on the remote.
1. Click ‘Start’ Button
2. Click ‘Windows Media Center’
3. Enjoy Windows Media Center
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10

Moneual 902 Ali User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI