Wolf WWD30O is a warming drawer designed for safely warming food and plates. With its versatile temperature range of 80 to 185 degrees Fahrenheit, you can warm a variety of dishes, from delicate pastries to hearty casseroles. The adjustable humidity control helps keep food moist and flavorful. The drawer can also be used to proof bread dough or thaw frozen foods.
Wolf WWD30O is a warming drawer designed for safely warming food and plates. With its versatile temperature range of 80 to 185 degrees Fahrenheit, you can warm a variety of dishes, from delicate pastries to hearty casseroles. The adjustable humidity control helps keep food moist and flavorful. The drawer can also be used to proof bread dough or thaw frozen foods.
Warming Drawer Installation Guide
WARMING DRAWER
Contents
3 Warming Drawer
4 Specications
7 Installation
7 Troubleshooting
Features and specications are subject to change at any
time without notice. Visit wolfappliance.com/specs for the
most up-to-date information.
2
|
Wolf Customer Care 800.222.7820
Important Note
To ensure this product is installed and operated as safely
and efciently as possible, take note of the following types
of highlighted information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION indicates a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specied.
IMPORTANT NOTE: Save these instructions for the local
electrical inspector.
SAVE THESE INSTRUCTIONS
wolfappliance.com
|
3
WARMING DRAWER
Product Information
Important product information including the model and
serial number are listed on the product rating plate. The
rating plate is located on the left front oor area of the inner
cabinet. The drawer must be open to view the rating plate.
Refer to the illustration below.
If service is necessary, contact Wolf factory certied service
with the model and serial number. For the name of the
nearest Wolf factory certied service or for questions
regarding the installation, visit the contact & support section
of our website, wolfappliance.com or call Wolf customer
care at 800-222-7820.
Rating plate location.
RATING
PLATE
4
|
Wolf Customer Care 800.222.7820
Installation Requirements
The warming drawer must be installed with a Wolf drawer
front, avail able through an authorized Wolf dealer. For local
dealer information, visit the nd a showroom section of our
website, wolfappliance.com. Specic installation instruc-
tions are included with the drawer front.
The warming drawer can be installed in a standard or ush
inset application (excludes L series drawer front).
Finish the edges of the opening. They may be visible when
the drawer is open.
For standard installations, face trim will overlap stiles and
rails. Refer to the chart below.
For ush inset installations, a minimum
1
/8" (3) reveal is
required on all sides. To ensure consistent reveals, each
corner of the opening must be exactly 90°.
An anti-tip block must be installed to prevent the warming
drawer from tipping forward when opened.
Model WWD30O is CSA approved for outdoor installations.
INSTALLATION REQUIREMENTS
BASE SUPPORT MIN
Warming Drawer 200 lbs (90 kg)
TRIM OVERLAP
Top, Bottom and Sides
5
/8" (16)
SPECIFICATIONS
Electrical
Installation must comply with all applicable electrical codes.
Locate the electrical supply ush with the back wall and
within the shaded area shown in the illustrations on the
following pages. For ease of installation, the electrical
supply for the warming drawer can be placed in an adjacent
cabinet within reach of the power cord.
IMPORTANT NOTE: When installed outdoors, a ground fault
circuit interrupter (GFCI) is required to reduce the risk of
electrical shock.
ELECTRICAL REQUIREMENTS
Electrical Supply grounded, 120 VAC, 60 Hz
Service 15 amp dedicated circuit
Receptacle 3-prong grounding-type
Power Cord 3'
(.9 m)
Rating plate location.
RATING
PLATE
wolfappliance.com
|
5
SPECIFICATIONS
Warming Drawer
STANDARD INSTALLATION
FRONT VIEW
SIDE
VIEW
TOP VIEW
NOTE: Location of electrical supply within opening may require additional cabinet depth.
23" (584)
OPENING
DEPTH
E
28
5
/8" (727)
OPENING WIDTH
9
1
/8" (232)
OPENING
HEIGHT
ANTI-TIP BLOCK
6
|
Wolf Customer Care 800.222.7820
SPECIFICATIONS
Warming Drawer
FLUSH INSET INSTALLATION
FRONT VIEW
SIDE
VIEW
TOP VIEW
*W
ill be visible and should be finished to match cabinetry.
**
Dimension provides minimum reveals.
NOTE: Dimensions provided allow for
1
/4" (6) reveal for proper air flow.
Location of electrical supply within opening may require additional cabinet depth.
24" (610)
FLUSH INSET
DEPTH
A
DRAWER
FRONT
DEPTH
10
5
/8"
(270)
FLUSH INSET
HEIGHT**
30
1
/8" (765)
FLUSH INSET WIDTH**
3
/4"(19)
3
/4"(19)
3
/4"(19)
E
E
FINISHED
CLEATS*
ANTI-TIP BLOCK
DRAWER FRONT DEPTH
M / E SERIES DRAWER FRONT A
Transitional / Professional 1
1
/8" (29)
Professional (2" thick) 2
1
/8" (54)
Contemporary 1
3
/8" (35)
Custom front panel depth is dependent on panel thickness.
wolfappliance.com
|
7
Troubleshooting
IMPORTANT NOTE: If the warming drawer does not operate
properly, follow these troubleshooting steps:
• Verify electrical power is supplied to the warming drawer.
• Verify proper electrical connections.
• If the warming drawer does not operate properly, contact
Wolf factory certied service. Do not attempt to repair
the warming drawer. Wolf is not responsible for service
required to correct a faulty installation.
Wolf, Wolf & Design, Wolf Gourmet, W & Design and the color red as applied to knobs are registered trademarks and service marks of Wolf Appliance, Inc. Sub-Zero,
Sub-Zero & Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, and Ingredients are registered trademarks and service marks
of Sub-Zero, Inc. All other trademarks or registered trademarks are property of their respective owners in the United States and other countries.
Preparation
Remove and recycle packing materials. Do not discard the
package containing two screws provided for installation.
Install an anti-tip block against the rear cabinet wall. Verify
screws are adequately secured and do not penetrate elec-
trical wiring or plumbing.
Installation
1 Turn power off to the electrical outlet.
2 Slide the left corner of the warming drawer into the
opening. If the electrical supply is located in the opening,
plug the power cord into the receptacle. If it is located in
an adjacent cabinet, guide the power cord through the
hole in the cabinet wall. Coil excess power cord behind
or beside the unit.
3 Slide the unit back into the opening until the trim
meets the cabinet front. Avoid pinching the power cord
between the unit and cabinet wall.
4 Open the warming drawer to full extension. Drill a pilot
hole in each mounting hole, located at the front, on each
side of the unit. Refer to the illustration below.
5 Mount the warming drawer using two screws provided.
6 Turn power back on to the electrical outlet.
INSTALLATION
MOUNTING
HOLE
Mounting hole.
WOLF APPLIANCE, INC. P.O. BOX 44848 MADISON, WI 53744 WOLFAPPLIANCE.COM 800.222.7820
9001600 REV-B 9/2014
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Wolf WWD30O is a warming drawer designed for safely warming food and plates. With its versatile temperature range of 80 to 185 degrees Fahrenheit, you can warm a variety of dishes, from delicate pastries to hearty casseroles. The adjustable humidity control helps keep food moist and flavorful. The drawer can also be used to proof bread dough or thaw frozen foods.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
