Thermador VTI1010D-01 Installation guide

Brand: Thermador

Model: VTI1010D-01

Type: Installation guide

Thermedor A, A,o_._c,o.gcon.

,4X IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS.

This appliance conforms to the relevant safety

regulations.

Repairs should only be carried out by qualified

specialists.

Improperly executed repairs can give rise to significant

hazards for the user.

Z_ Your new appliance was protected on its way to

you by the packaging. None of the materials

cause

pollution to the environment and all can be recy-

cled for use again. Please help to protect the

environment and dispose of the packaging in an

environment-friendly manner.

You can obtain information about the best

method

disposing of old appliances and packaging from

your dealer or local municipal council.

Check whether this fan may be combined with

the extractor hood.

SAFETY WARNING: Before servicing or cleaning

unit, switch power off at the service panel and

lock service disconnecting means to prevent

power from being switched on accidentally.

When the service disconnecting means cannot

be locked, attach a tag to the service panel to

indicate power has been switched off for

maintenance.

WARNING - TO REDUCE THE RISK OF FIRE,

ELECTRIC SHOCK, OR INJURY TO PER-

SONS, OBSERVE THE FOLLOWING:

Installation work and electrical wiring must be

done by qualified person(s) in accordance with all

applicable codes and standards, including fire-

related construction.

Sufficient air is needed for proper combustion

and exhausting of gases through the flue

(chimney) of fuel burning equipment to prevent

back drafting. Follow the heating equipment

manufacturers guideline and safety standards

such as those published by the National Fire

Protection Association (NFPA),and the American

Society for Heating, Refrigeration and Air

Conditioning Engineers (ASHRAE), and the local

code authorities.

When cutting or drilling into wall or ceiling, do not

damage electrical wiring and other hidden utilities.

To properly exhaust air, be sure to duct air out

side. Do not vent exhaust air into spaces within

walls, ceilings, attics, crawl spaces, or garages.

WARNING: To reduce the risk of fire, use only

metal ductwork.

CAUTION - For General Ventilating Use Only.

Do Not Use To Exhaust Hazardous Or Explosive

Materials And Vapours.

This unit must be grounded.

WARNING: To reduce the risk of fire or electric

shock, do not use this fan with any solid-state

speed control device.

Equipment Needed

[] Drill and Bit

[] Screwdriver

[] Rubber Mallet

Equipment Included

[] Anchors (4)

[] Screws (4)

[] Installation Instructions

[] Connector

PAGE 1

PRIOR TO INSTALLATION

Step 1' EXHAUST-AIR MODE

_.s_Exhaust air should neither be directed into a smoke or

exhaust flue that iscurrently used for other purposes, not

into a shaft that is used for ventilating rooms in which

stoves or fireplaces are also located.

Exhaust air may be discharged in accordance with

official and statutory regulations only (e.g. national

building regulations).

Local authority regulations must be observed when

discharging air into smoke or exhaust flues that are not

otherwise in use.

_:_-_When the extractor hood is operated in exhaust-air

mode simultaneously with a different burner which

also makes use of the same chimney (such as gas, oil

or coal-fired heaters, continuous-flow heaters, hot-water

boilers) care must be taken to ensure that there is an

adequate supply of fresh air which will be needed by

the burner for combustion.

Safe operation is possible provided that the underpressure

in the room where the burner is installed does not exceed

4 Pa (0.04 mbar).

This can be achieved if combustion air can flow through

non-lockable openings, e.g. in doors, windows and via the

air-intake/exhaust-air wall box or by other technical

measures, such as reciprocal interlocking, etc.

If the air intake is inadequate, there is a risk of

poisoning from combustion gases which are drawn

back into the room.

An air-intake/exhaust-air wall box by itself is no guarantee

that the limiting value will not be exceeded.

Note: When assessing the overall requirement, the

combined ventilation system for the entire household must

be taken into consideration. This rule does not apply to

the use of cooking appliances, such as hobs and ovens.

Z_ The fan must be attached at least 78 3/4"from the

extractor hood.

Z_ Attach the inner wall fan inside the building only, but

not in living rooms.

Z_ When attaching the inner wall fan, ensure that it is

accessible for maintenance and repairs.

Z_ The plug-and-socket connections of the electric

cables must be located inside the building, according to

local code.

Z_ Do not reduce the 10" diameter of the pipes

connected to the extractor hood.

Step 2: PREPARING THE WALL

[] The wall must be flat and perpendicular.

[] Ensure that the wall is capable of providing a firm hold

for mounting screws and plugs.

Weight in kg: 15,4

We reserve the right to construction changes within the

context of technical development.

PAGE 2

INSTALLATION

1. Hold the fan on the wall.

Note the direction of the air conduction.

2. Mark the 4 mounting boreholes.

/_ At least one screw must be installed through a stud.

/_ The wall plugs must be suitable for the brickwork.

3. Drillthe 4 x 1/4"¢ mounting boreholes.

Insert wall plugs and screw the fan to the wall.

4. Connect the pipe from the fan to the extractor hood and

feed to the outside.

5. Connect the fan to the extractor hood with an extension

cable if required.

Use the added connector.

Use the wire diagramm for connecting.

/_ The additional cover on the plug must always be

attached and closed for safety reasons.

/_ Not needed wires must be isolated, capped with

wire nuts and stored in a safe position.

iilii%......

PAGE 3

WIRE DIAGRAMM

green/yeUow

speed 4

speed 3

, speed 2

speed 1

1, 1112

2 C2

] GJ

4--

cJ N

(u _ C

I L2 L3 ) L4 •

speed 4

speed 3

speed 2

speed 1

111 2

1 2 3 4) 5

X8h

speed 1

speed 2

speed 3

speed 4

(red)

(blue)

(orange)

(brown)

(white)

(green/yellow)

PAGE 4

5551 McFadden Avenue, Huntington Beach CA, 92649 • 800-735-4328 • www.thermador.com

Thermador VTI1010D-01 Installation guide

Thermador VTI1010D-01 Installation guide

Thermador VTI1010D-01 Installation guide

Related papers

Other documents