Barco service bulletin
Overview
• Improved slave behavior a fter power interruption
• Full support for t he new DVI board
• DVI input errors when p reviously selecte d HDTV sources solved
• Sync On Green errors solved
• new image file for 1920x1200 resolution
• led blinking when projector is in standby and Se rver is running
• ftp client hanging is solved
• too long upgrade (via ftp) is solved (only effective after Server upgrade to V1.25)
• Full screen representation menu item re m oved from osd
• new aspect ratio 16:10 ( see menu below )
• x,y added to the custom aspect ratio dialog box (see dialog box below)
• YUV/RGB statu s is memorized per layer
• VR Workroom : Single VR mode added : one projector is working i.e. the other server is
still active to allow master-slave communication (selection based on the shortest lamp
lifetime)
• VR Workroom : full system shutdown added to the Start menu: allows to switch off
both projectors and Servers
Image 1-1
Image 1-2
1.2 Upgrade procedur
e
How to upgrade t
he firmware and server s oftware ?
1.See the service ma nu al for a de tailed description.
InfoT:
InfoT657
Page 2 of 2