Ranger design 6092-42 Installation guide

  • Hello! I'm your chat assistant, and I've reviewed the Installation Guide for the RANGER DESIGN LED Lighting Kit 6092-42. This document provides detailed instructions on how to install the light bar, connect the extension cables, and wire the light to your vehicle's fuse box. The kit operates on 12V DC and provides 1200 lumens of light output. I'm here to answer any questions you might have about its installation or features.
  • What is the voltage of the light kit?
    What is the light output of this kit?
    Where should I wire the light kit?
INSTALLATION GUIDE
6092-42 Universal led lighting Kit
Universal Light Kit for Trucks & Vans
12V DC
1200 Lumens
10W
QUICK START GUIDE
REQUIRED ITEMS
1
PERSON
q 1.1 Setup............................................................................................................................................... 3 - 4
Phase 1 - Assembly
Phase 2 - Installation
4 - 5
q Tape Measure
q Marker
q Cordless Impact
q Phillips Screwdriver Bit
q 2.1 Light Bar Installation.......................................................................................................................
For technical support, contact us at 1-800-565-5321 6092-42 Installation Guide | REV. A1 | Page 3
PHASE 1 – ASSEMBLY
1.1 SETUP
1.1.1 Unpack components; compare with the bill of materials.
1.1.2 Verify all parts are present.
Item No. Description Qty.
Light Bar Light Bar w/ Extension Cable 1
Extension Cable 48" Extension Cables ( 80°c, 300v, 22awg ) 1
96-6017 Brackets and Screws 1
BILL OF MATERIALS
Light Bar
Extension Cable
96-6017
For technical support, contact us at 1-800-565-5321 6092-42 Installation Guide | REV. A1 | Page 4
Bracket & Screw
Bracket & Screw
Light Bar
1.2.1 Peel the 3m cover tape off the Light bar, then place the Light bar in the desired position.
1.2.2 Screw the brackets to the vehicle, cliping the Light bar.
PHASE 2 – INSTALLATION
2.1 LIGHT BAR INSTALLATION
TOOLS
q Cordless Impact
q Phillips Screwdriver Bit
TOOLS
q Marker
q Tape Measure
HARDWARE USEDHARDWARE USED
SCREW
For technical support, contact us at 1-800-565-5321 6092-42 Installation Guide | REV. A1 | Page 5
1.2.4 To attach an additional Light bar, install the second Light bar as shown on page 4, then connect one
end of the 1st Light bar to the extension cables and the other end of the extension cable to the
2nd Light bar.
1.2.3 • Connect one end of the extension cables to the Light bar, then cut off the other end of the extension
cables and strip the wires.
• Using the supplied end connectors, join the positive wire to the red wire of the extension cables and join
the negative wire to the black wire of the extension cables.
• Red wire to Positive wire
• Black wire to Negative wire
End Connectors
Connect
60-001
60-002
NOTE: • The extension cables wire is 80°c, 300v and 22awg.
Wire the LED light through the vehicle fuse box not directly to the battery.
NOTE: Maximum of 4
For technical support, contact us at 1-800-565-5321 6092-42 Installation Guide | REV. A1 | Page 6
“You have successfully installed your
6092 - 42
Thank you for doing business with us.”
For any feedback or suggestions you may have, please contact: cs@rangerdesign.com
/