American Standard 6093 Installation guide
- Category
- Wall & ceiling mounts accessories
- Type
- Installation guide
Certified to comply with ANSI A112.18.1
1
18" TOWEL BAR, 24" TOWEL BAR, GLASS SHELF AND TOILET TISSUE HOLDER
MOUNTING BRACKET INSTALLATION
The 18" TOWEL BAR, 24" TOWEL BAR, GLASS SHELF and TOILET TISSUE HOLDER work best if secured to a wall stud or cross brace
within the wall, using the SCREWS (4) supplied.
If the 18" TOWEL BAR, 24" TOWEL BAR, GLASS SHELF and TOILET TISSUE HOLDER are to be installed on a tile or plaster wall the
ANCHORS and SCREWS should be used.
ACCESSORIES
Installation
Instructions
6090
6091
6092
6093
6028.230
6028.180
6028.244
6028.024
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read instructions carefully before you begin.
INSTALL 18" TOWEL BAR, AND 24" TOWEL BAR
2
TOILET TISSUE HOLDER
18"TOWEL BAR
24"TOWEL BAR
GLASS SHELF
Regular Screwdriver
Level
Recommended Tools
Phillips Screwdriver
Drill
10'
Tape Measure
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR
WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: CLEAN THE PRODUCT WITH SOAPS, ACID,
POLISH, ABRASIVES, HARSH CLEANERS, OR A CLOTH
WITH A COARSE SURFACE.
Secure MOUNTING PLATES (1) to wall with SCREWS (2).
For installations on tiled walls, If TILE ANCHORS (4) and SCREWS (2) are used for securing MOUNTING BRACKET (1), then
drill two 1/4" diameter holes a minimum of 1-1/4" deep. Insert the two TILE ANCHORS (4) flush with face of the finished wall.
Determine desired height and location (optional) for the accessory and mark a center line. Use the full size template supplied to mark
hole locations for the mounting brackets. For the 24" TOWEL BAR and GLASS SHELF use 24” template. For 18” TOWEL BAR use 18”
template. For the TOILET TISSUE HOLDER use the 7” template. If MOUNTING BRACKET (1) is secured to a stud or cross brace drill
small pilot holes for SCREWS (2).
For installations on drywall, use DRYWALL ANCHOR (3) and SCREWS (2) for securing MOUNTING BRACKETS (1) to wall. Place #2 Phillips
screwdriver or cordless screwdriver into recess of anchor. Press into drywall while turning the anchor clockwise until it is seated flush with
the wall. Place MOUNTING BRACKET (1) over DRYWALL ANCHORS (3) and insert screws provided with #2 Phillips screwdriver. See
illustration below. Secure MOUNTING BRACKETS (1) to wall with SCREWS (2).
Place right ESCUTCHEON (5) onto MOUNTING BRACKET (1), and secure
with SET SCREW (6) using 2.5 mm HEX WRENCH (7) supplied.
Insert each end of TOWEL BAR (8) into the CRANKS (9).
Place LEFT ESCUTCHEON (5a) onto MOUNTING BRACKET (1a) and
secure with SET SCREW (6) using 2.5 mm HEX WRENCH (7) supplied.
M968860 REV. 1.1
5
5
8
1a
1
6
6
6
5a
5a
3
4
FINISHED WALL
1
3
4
1
2
DRILL PILOT HOLE FOR
WOOD SCREW (1) OR
1/4" DIA. HOLE FOR
ANCHOR (4)
CENTER
LINE
SLOT
CENTER LINE
(OPTIONAL TO
FINISHED FLOOR)
CENTER
LINE
LEVEL
TEMPLATE
FINISHED WALL
DRILL PILOT HOLE FOR
WOOD SCREW OR
1/4" DIA. HOLE FOR
ANCHOR
CENTER LINE
ANCHORS (FOR TILED WALLS)
DRYWALL ANCHORS
7"
24"
18"
18" TOWEL BAR
24" TOWEL BAR
TOILET TISSUE HOLDER
GLASS SHELF
6090
6091
60936092
7
9
9
3
INSTALL GLASS SHELF
M968860 REV. 1.1
Place ESCUTCHEON (1,1a) onto installed MOUNTING
BRACKETS (2) and secure with SET SCREWS (3) using
2.5mm HEX WRENCH (4) supplied.
Remove SCREW (5) and top WASHER (6) from SHELF
RISER (7).
Install GLASS SHELF (8) onto SHELF RISERS (7).
Secure GLASS SHELF (8) with SCREWS (5) and
WASHERS (6).
4
INSTALL TOILET TISSUE HOLDER
Place ESCUTCHEON with TISSUE PAPER ROD ATTACHED (1) onto LEFT MOUNTING BRACKET (2) and secure with
SET SCREW (3) using 2.5mm HEX WRENCH (4) supplied.
Attach ESCUTCHEON (1A) to RIGHT MOUNTING BRACKET (2A) and secure with set screw (3) using 2.5mm HEX WRENCH (4) supplied.
Swing TISSUE PAPER ROD (5) onto LATCH (6) at the tip of the
RIGHT ESCUTCHEON (1A) to complete assembly.
6
6
7
7
5
6
5
5
8
2
2
4
2
2A
1A
5
6
1
1a
1a
1
3
3
3
2
4
1
1A
3
3
FINISHED WALL
FINISHED WALL
1
7”
2
2
OPTIONAL TO
FINISHED FLOOR
CENTER LINE
CENTER
LINE
FINISHED WALL
DRILL PILOT HOLE FOR
WOOD SCREW OR
1/4" DIA. HOLE FOR
ANCHOR
CENTER LINE
ANCHORS (FOR TILED WALLS)
DRYWALL ANCHORS
7"
24"
18"
18" TOWEL BAR
24" TOWEL BAR
TOILET TISSUE HOLDER
GLASS SHELF
6090
6091
60936092
ACCESSORIES
18” & 24" TOWEL BAR; GLASS SHELF;
TOILET TISSUE HOLDER
CHROME
BRUSHED BRASS
SATIN
002
275
295
Replace the "YYY" with
appropriate finish code
18” & 24" TOWEL BAR
24" GLASS SHELF
TOILET TISSUE HOLDER
MODEL NUMBERS
M968860 REV. 1.1
M922342-YYY0A
CRANK
M919215-YYY0A
BAR 18”
M919216-YYY0A
BAR 24”
M962437-YYY0A
INDEX BUTTON
& O-RING
M918659-0070A
SCREW
M918659-0070A
SCREW
HOT LINE FOR HELP
For toll-free information and answers to your questions, call:
1-800 442-1902
Weekdays 8:00 a.m. to 8:00 p.m. EST
IN CANADA 1-800-387-0369 (TORONTO 1-905-306-1093)
Weekdays 8:00 a.m. to 7:00 p.m. EST
Product names listed herein are trademarks of American Standard Inc.
© American Standard Inc. 2005
M962438-YYY0A
ESCUTCHEON
M962442-YYY0A
ESCUTCHEON & ROD
M962433-0070A
MOUNTING KIT
M962433-0070A
MOUNTING KIT
M962433-0070A
MOUNTING KIT
M917139-0070A
SET SCREW
M917139-0070A
SET SCREW
M917139-0070A
SET SCREW
M962441-YYY0A
ESCUTCHEON ASSEMBLY
M962439-YYY0A
END CAP & O-RING
M962437-YYY0A
INDEX BUTTON
& O-RING
M922347-YYY0A
RAISER
M922275-0070A
GLASS SHELF
M962438-YYY0A
ESCUTCHEON
M962350-0070A
SHELF MOUNTING KIT
M962433-0070A
MOUNTING KIT
IN MEXICO 01-800-839-12-00
6090
6091
6092
6093
6028.230
6028.180
6028.244
6028.024
-
1
-
2
-
3
American Standard 6093 Installation guide
- Category
- Wall & ceiling mounts accessories
- Type
- Installation guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
American Standard 8040.300 User manual
-
-
-
-
-
-
American Standard 6092 User manual
-
American Standard 2555.021 Installation guide
-
-
