2. Computers & electronics
  3. Computers
  4. Notebooks
  5. Notebook arms & stands
  6. standivarius
  7. ORYX
ORYX

standivarius ORYX User manual

  • Hello! I have analyzed the provided user manual for the standivarius oryx laptop and tablet stand. This document provides instructions on how to assemble and adjust the stand for optimal use. The manual details how to attach devices, adjust height and viewing angles, and offers tips for maintaining the stand. I'm ready to answer any questions you have.
  • How can I adjust the height of the stand?
    How do I attach my tablet to the stand?
    What if the U-shaped tab loses its stick?
    Can the viewing angle of tablet be adjusted?
6
5 cm
5 8
5. Remove transparent protective film from U- shaped tab and stick firmly to the back of the
tablet on the centre-line approximately 5 cm from the bottom. (Tip: use measure on the side
of this sheet printed at real size, no scaling)
6. Follow steps 2 & 3 above and set-up the stand on highest setting. Extend the tablet
support and place tablet in position.
Tablet:
7. Push out the retaining tongue on the stand, fold down the end section and tuck it down into
the U-shaped tab.
8. Position the stand on your desk about an arm's length away. Add an external mouse and
keyboard to create an ergonomic workstation.
Laptop: 1. Push to form laptop/document support. 2. Unfold rear support. 3. Select one of four height settings. 4. Place laptop and document on stand to view.
The ideal viewing angle will depend on user preference as well as
the thickness of the tablet, so we suggest starting with the tab in the
position shown in step 5 and moving it down the tablet by up to 2 cm
to adjust the angle. (Tip: watch assembly video:
standivarius.com/oryx-pro). When using tablets in portrait
orientation, the lower laptop support may offer better stability than
the upper tablet support.
The tablet height can be raised and lowered using the four settings
on the stand; the screen viewing angle can be adjusted by changing
the position of the U-shaped tab on the tablet.
Tablet height/angle:
Important – read before use
7
The gel tab is a tested method of retaining the tablet on the stand,
but it remains the user's responsibility to ensure that the device is
properly secured at all times. DMR Ergonomics does not accept
liability for damage to any device as a result of improper use of this
stand.
Safety:
The U-shaped tab can be left on the tablet or gently eased off. (Tip:
Slide a credit card between the gel and the tablet to ease the tab
off). The reusable nano PU gel leaves no residue and has high
strength and viscosity, but if it loses its stick, then simply rinse in
water, air-dry and reuse. A spare tab has been included with this
product for your convenience.
Removing U-shaped tab:
How to assemble your oryx
www.standivarius.com
/