CONCORD ELEVATION Assembly Instructions Manual

Brand: CONCORD

Model: ELEVATION

Type: Assembly Instructions Manual

The Responsible Solution

Elevations Assembly

Instructions

ITEM DESCRIPTION QTY

CROSS BRACE

BOLTS

(OPTIONAL)

WORKSURFACE 1

CONTROL BOX 1

HANDSET,

CONTROL BOX AND

P-CLIP FASTENERS

CONTROL BOX

POWER CORD

LEG ASSEMBLY

MOUNTING

FASTENERS

LEG ASSEMBLY 2

HANDSET

CROSS BRACE

FASTENERS

(OPTIONAL)

STEP 1: ASSEMBLE FRAME Set worksurface upside down on a flat stable surface. Locate 2 leg assemblies and cross braces (if included)

on work surface. If your table has only one cross brace, position the cross brace to the back of the worksurface. Insert cross brace

fasteners hand tight (3 locations on each cross brace end, see FIGURE "A"). If your table does not require a cross brace proceed to STEP 2.

STEP 2: ASSEMBLE TABLE Locate each leg assembly on the work surface per drawing template.(see Figure" B"). Locate each leg assembly on the

front to back center line of the work surface (see FIGURE "C"). If your table has a cross brace locate the center line of the cross brace on the right

to left center line of the work surface (see FIGURE "C"). Proceed to insert the leg assembly mounting fasteners, 8 per leg (FIGURE "B").Once the

legs are fastened to the worksurface completely tighten the cross brace fasteners.

STEP 3: ASSEMBLE ELECTRONICS Locate the handset and control box on the work surface as shown in Figure "E", Figure "F" and Figure

"G".Once the control box and handset are located in their approximate position, insert the corresponding mounting fasteners.

STEP 4: ELECTRICAL CONNECTIONS DO NOT PLUG IN POWER CORD INTO THE ELECTRICAL OUTLET UNTIL LEG ASSEMBLIES AND HAND-

SET ARE CONNECTED TO CONTROL BOX. Connect handset cord and leg assembly cords, to the control box. See FIGURE "I".Use wire P-clip

fasteners to secure wires to tabletop. Once connections are made, upright the table and plug in the power cord.

*WARNING: Do not swap the control box or legs with other tables, as this may cause the legs to become out of sync and cause damage.

STEP 5: LEVELING TABLE Adjust glides until work surface is level. (FIGURE "J")

CROSS BRACE FASTENERS (OPTIONAL)

STEP 6: FIRST TIME INITIALIZING THE LEGS.Depress and hold the down button. The table will move slightly down and then slightly back up.

Release the down button. The legs are now initialized and ready for use.

Press the memory key.

The display will read S-.

Press and hold the desktop down key (down arrow) for

approximately 5 seconds.

The display will start flashing.

Adjust the height display by pressing the down and up

arrows

Press the memory key.

STEP 7: CHANGING THE DISPLAY HEIGHT. If the display height does not match the actual height of the table top, follow these steps.

The Responsible Solution

www.concordproducts.com

1.800.220.5043

COMMITTED TO:

the environment

responsible manufacturing

minimal waste

® Trademarks of Concord Products Company, Inc.

INSTAL-ELEVATION-0121

CONCORD ELEVATION Assembly Instructions Manual

CONCORD ELEVATION Assembly Instructions Manual

CONCORD ELEVATION Assembly Instructions Manual

Other documents