Baby Alert ChildMinder Quick start guide

Brand: Baby Alert

Model: ChildMinder

Type: Quick start guide

5. Smart Clip will beep 4 times letting you know that the battery is

correctly installed and that the Smart Clip is ready to be activated.

Key Ring Unit

1. Key Ring Unit comes with batteries pre-installed.

a) With the reverse side of the Key Ring Unit facing upwards, remove

the plastic tab by pulling outwards from the Key Ring Unit battery

compartment.

b) Press and hold the Center Button for one second, unit beeps ten

(10) times with Green LED illuminating at the same time, then

extinguishes. Your Key Ring Unit is now ready to be activated.

2. Battery Replacement

a) With the back side of the Key Ring Unit facing upwards, pull the

battery door clockwise.

b) Place lithium CR2450 battery into holder making sure that battery

makes contact with the internal ring and the positive (+) side of

battery facing up.

Installation of the ChildMinder

System

Smart Clip Unit

Follow your Child Restraint System (CRS) procedures for instructions on

removal and installation of your CRS’s chest harness clip.

Installation of the ChildMinder

Key Ring Unit

Attach the Key Ring Unit to the child’s caregiver’s drivers’ automotive

key ring.

Using your ChildMinder Smart Clip

Single Unit Key Ring

1. Follow your usual procedures for securing your child in their CRS

system.

2. Upon fastening the Smart (Chest Harness) Clip (insert Smart Clip Part

B to Smart Clip Part A), Smart Clip will began to beep with Green LED

flashing.

3. Press and hold the Center Button on the Key ring Unit for One second

or until Key Ring Unit beeps.

4. The Smart Clip will stop beeping and Red LED will began flashing

on the Smart Clip and on the Key Ring Units. Your system is now

activated (armed).

(continue

→

)

Getting Started

Your Smart Clip and Key Ring Unit come with batteries pre-installed.

Battery Installation/Replacement

Smart Clip Battery: Separate Part A from Part B

1. With battery compartment facing upwards, with a coin remove

battery cover by turning cover counter clockwise ¼ turn until you

feel cover click.

2. Remove the plastic strip outwards from under the battery cover and

properly discard.

3. Confirm the placement of a CR2450 battery into Part B battery

compartment with positive side of battery facing upwards (side of

battery with writing).

4. Replace battery cover on battery compartment and secure battery

cover by aligning the pin hole on the battery cover with the pin hole on

Part B with ¼ turn clockwise or in the direction indicated for close.

QUICK TAKE

Welcome to the Baby Alert International Family of Proactive

and Interactive Child Safety Products!

Congratulations on your purchase of the

ChildMinder

System.

For optimum performance and serviceable life of your product, please take

time to carefully review you’re your instruction manual. (Available via

download on www.babyalert.info under “Product User Guides”.)

CAUTION! Even when used properly and in accordance to its intended

purpose, The ChildMinder

System serves only as a supplemental safety

support, the ultimate, primary and in many states legal responsibility of the

safety of your child resides with the child’s parents and caregivers.

The ChildMinder Systems does not represent any attempt to circumvent,

mitigate, nor represents a substitution for the parental and or caregivers’

legal duties under applicable states laws.

Part B Part A

Battery DoorCenter Button

Learn Button

Lithium

CR2450 Battery

SMART CLIP CLOSED (front)

SMART CLIP OPEN (front)

LED

Indicator

Learn Button

Part B Part A

Battery Cover

Release

Buttons

KEY RING (front) KEY RING OPEN (back)

SMART CLIP OPEN (back)

Low Battery Warning

Key Ring Unit

Upon activation, the Key Ring Unit will emit an intermittent beep while

its Red and Green LEDs flash simultaneously, indicating the need to

replace its battery.

Smart Clip Unit

Upon activation, the Smart Clip Unit will emit an intermittent beep

while its Red and Green LEDs will flash simultaneously, indicating the

need to replace its battery.

CAUTION! Although the ChildMinder

System will continue to actively

warn the parent or guardian of unattended parent/child separation, even

during its low battery status, you should replace batteries at your earliest

convenience.

Troubleshooting

DO NOT ATTEMPT to modify either unit. Any modifications to either

unit can void the operator’s authority to operate the equipment and all

warranties.

1. When in the Alarm Mode, the Key Ring Unit’s audible alarm may

only be extinguished by:

a) an eight second delay after the Key Ring and Smart Clip Units

have been returned within 15 meters each other;

b) returning the Key Ring Unit within proximity of the Smart

Clip Unit.

2. Smart Clip Deactivation while Key Ring Unit is in Alarm Mode.

Should the Smart Clip Unit be deactivated while the Key Ring Unit is

in the Alarm Mode (15 meters or more from Smart Clip), the Key Ring

Unit will continue to beep even upon returning to proximity of the

deactivated Smart Clip Unit.

Solution:

To extinguish the beeping of the Key Ring Unit, the Key Ring Unit

must be reset as follows:

a) remove batteries from the Key Ring Unit and then replace batteries

(not recommended)

b) activate the Smart Clip Unit (see “Engaging Alarm System” on other

side) with the continuously beeping Key Ring Unit within 15 meters

of each other.

Learning Feature of Key Ring Unit

Although the Key Ring Unit and the Smart Clip Unit are factory

pre-programmed to communicate with each other, purchase of

supplemental Key Ring Units may be required to “learn” your system.

Learning:

With the Smart Clip Unit activated (Smart Clip Unit Part A and Part B

together):

1. Press and release the Learn Button on the Smart Clip, unit beep will

change and both Red and Green LEDs will begin flashing.

2. Press the Center Button on the Key Ring Unit, the Key Ring Unit will

begin beeping.

3. With a pen, press the Learn Button of the Key Ring Unit. The Key

Ring Unit beep will change while both Red and Green LEDs begin

flashing.

4. The Smart Clip and Key Ring will beep two times and LED will

illuminate Green.

5. The Key Ring Unit is now matched with the Smart Clip Unit.

ChildMinder is a registered trademark of Baby Alert International, Inc.

Multi-Unit Key Ring

Follow same procedures for activation. The Mutli-Unit key ring will

connect with up to 4 Multi-Child Smart Clips. To activate more than one

Smart Clip to your Multi-Unit Key Ring:

1. Activate up to 4 Multi-Child Smart Clips at the same time, then press

the Multi-Unit Key Ring Center Button and hold for one second or

until you hear the Multi-Unit Key Ring beep.

2. The Smart Clips will stop beeping. The Multi-Unit Key Ring is now

connected to all Multi-Child Smart Clips.

Engaging System Alarm

1. The Key Ring Unit will alarm within eight (8) seconds after a distance

of 15 meters from the activated Smart Clip(s).

2. The Key Ring Unit will continuously beep until either:

a) the Smart Clip is opened and your child is removed from the Child

Safety Seat; or

b) eight seconds after the Key Ring and Smart Clip Unit(s) are

returned within 15 meters of each other.

Deactivation of ChildMinder

System

1. At the same time, squeeze the release buttons on Smart Clip Unit Part

A while gently pulling outward on both Smart Clip Unit Parts A & B.

2. Separate Smart Clip Unit Part A from Smart Clip Unit Part B.

3. Allow up to 8 seconds for complete deactivation.

4. The Smart Clip will beep 4 times then the Key Ring Unit will

beep 4 times. The ChildMinder

System is now deactivated

(Disarmed).

Multi-Child Smart Clips

1. Follow your normal procedures for removing your children from the

child safety seats.

2. You may remove the children from their child safety seat one at a time

or all at same time.

3. As each child is removed from their safety seat (deactivation) the Smart

Clip Unit will beep 4-5 times (allow up to 4 seconds).

4. The Multi Key Ring Unit will beep only one time for each Clip

deactivation.

5. Upon the last Clip deactivation, the Multi-Unit Key Ring will beep 4-5

times and then shut off.

Baby Alert ChildMinder Quick start guide

Brand: Baby Alert

Model: ChildMinder

Type: Quick start guide

Download PDF

report

Baby Alert ChildMinder Quick start guide

Baby Alert ChildMinder Quick start guide

Related papers

Other documents