6
Column oven installation
Instructions
Important: Make sure to disconnect the oven from the power supply before carrying out any
installation or maintenance work on the appliance.
_
Installation must be carried out by a qualified technician in compliance with the manufacturer's
instructions and the local regulations on safety.
_
After unpacking the oven make sure it was not damaged during transport and that the door closes
properly.
In case of problems, contact the dealer or your nearest After-Sales Service Centre
.
_
After unpacking the oven, leave it on the polystyrene base to prevent it from being damaged.
_
It is advisable to wear protective gloves when installing the appliance.
_
The oven is provided with two side handles
(B)
to facilitate installation (Fig. 7).
Preparing the cabinet for fitting
_
Kitchen units next to the oven must be heat resistant (min. 80 °C).
_
Carry out all cabinet cutting work before installing the appliance in it. Make sure to remove all wood
chips and sawdust, which could hinder proper operation of the appliance.
_
In case of installation as shown in Fig. 2, recipients containing liquids must not be placed on the top part
of the column unit. Grilles can be applied to partly close the opening, in any case maintaining a useful
area of 100 cm
2
.
_
The dimensions of cabinets for fitting are given in figures 1, 2 and 3. Oven dimensions are given in fig. 4.
_
To ensure adequate ventilation, leave an open space at the back of the cabinet (respecting the dimensions
given in Fig. 6).
After installation, the bottom of the oven must no longer be accessible
.
_
Install the oven making sure its walls do not directly touch the adjacent kitchen units (Fig. 5).
1
2
3
4
10200337GB.fm Page 6 Thursday, September 13, 2007 11:33 AM