9
INSTRUCTIONS FOR USE
BEFORE USING THE COOKING HOB
INSTALLATION - TECHNICAL INFORMATION FOR THE
INSTALLER
PROTECTING THE ENVIRONMENT
PRECAUTIONS AND GENERAL ADVICE
ENERGY SAVING TIPS
CARE AND CLEANING
TROUBLESHOOTING GUIDE
AFTER SALES SERVICE
6en66008.fm Page 9 Tuesday, March 18, 2003 9:44 AM
10
BEFORE USING THE COOKING HOB
INSTALLATION - TECHNICAL INFORMATION FOR THE
INSTALLER
• To make the most of your new appliance, please read the user instructions carefully and keep them to hand
for future consultation.
•
Make sure that the appliance is installed and connected to the
electricity supply by a qualified technician in accordance with the
manufacturer’s instructions and in compliance with local
regulations.
•
Before installation, please read the following recommendations:
•
Make sure the cooking hob is fitted in a level position.
•
If the cooking hob is to be installed next to a kitchen unit, leave a
distance of at least 50 mm between them.
•
If a hood or shelf is to be installed above the cooking hob, leave a
minimum distance of at least 650 mm between them
•
Kitchen unit surfaces near the cooking hob must be heat resistant
•
Do not position the cooking hob near flammable materials
(e.g. curtains).
•
There must be a space of at least 50mm between the cooking hob
and the wall behind it.
6en66008.fm Page 10 Tuesday, March 18, 2003 9:44 AM
11
Electrical Connections
•
It is the responsibility of the installer to ensure correct electrical
connection of the appliance and to follow the recommended safety
regulations.
•
After checking that your mains voltage is the same as that shown
on the rating plate and that the wiring is of sufficiently heavy
gauge for the current load, the appliance may be connected.
•
Fit a standard plug (where applicable). First make sure that the plug
is correctly rated for the power consumption of the hob.
•
Plug the appliance in to an earthed socket.
•
Do not use multiple plug adapters or extension cables.
•
Connection to the mains must be through an omnipolar switch which
has a contact gap of at least 3 mm.
•
When the appliance is installed, the switch or socket must always
be accessible.
•
The supply cable must not come in contact with hot surfaces and
must be positioned so that it does not at any time exceed the
temperature of 50°C.
•
After the appliance has been installed, the electrical components
must not be accessible.
The producer does not accept responsibility for any damage or injury to
persons or property resulting from non-observance of these
requirements.
Replacing the supply cable
The supply cable may be replaced with a new one of the same type and
connected to the junction box.
Use cable type H05RR-F
1) For Great Britain only
Warning - this appliance must be earthed
Fuse replacement
If the mains lead of this appliance is fitted with a BS 1363A 13 amp
fused plug, to change a fuse in this type of plug use an A.S.T.A.
approved fuse to BS 1362 type and proceed as follows:
1.
Remove the fuse cover (
A
) and fuse (
B
).
2.
Fit replacement 13A fuse into fuse cover.
3.
Refit both into plug.
Important:
The fuse cover must be refitted when changing a fuse and if the fuse
cover is lost the plug must not be used until a correct replacement is
fitted.
Correct replacement are identified by the colour insert or the colour
embossed in words on the base of the plug.
Replacement fuse covers are available from your local electrical store.
2) For the Republic of Ireland only
The information given in respect of Great Britain will frequently apply,
but a third type of plug and socket is also used, the
2-pin, side earth type.
3) Socket outlet / plug (valid for both countries)
If the fitted plug is not suitable for your socket outlet, please contact
Whirlpool Service for further instruction. Please do not attempt to
change plug yourself. This procedure needs to be carried out by a
qualified Whirlpool technician in compliance with the manufactures
instructions and current standard safety regulations.
6en66008.fm Page 11 Tuesday, March 18, 2003 9:44 AM
12
PROTECTING THE ENVIRONMENT
1. Packaging
The packaging material is entirely recyclable, as
confirmed by the recycling symbol .
2. Electrical household appliances
The appliances are built from recyclable materials.
Respect local bylaws when disposing of unwanted
electrical household appliances. Before disposing of
appliances, cut the power supply cables so that they
cannot be reconnected.
Declaration of conformity
These appliances are designed to come into contact with
foodstuffs and they are constructed in compliance with
Directive 89/109/EEC
•
The appliances are designed solely for use as cooking
appliances. Any other use of the appliances (e.g. for
room heating) is considered as improper use and is
potentially dangerous.
•
The appliances are designed, built and sold in
compliance with:
•
The safety requirements of Low Voltage Directive
73/23/EEC,
•
The protection requirements of EMC Directive
89/336/EEC,
•
The requirements of Directive 93/68/EEC.
•
Electrical insulation: Class
(I)
.
PRECAUTIONS AND GENERAL ADVICE
•
Before doing any maintenance work on the appliance,
disconnect it from the electrical power supply.
•
Keep children away from the cooking hob when it is
in use and when it has just been switched off.
•
The appliance must only be repaired or adjusted by a
qualified technician.
•
Make sure that the wires of other electrical appliances
near the cooking hob do not come into contact with its
surrounding hot surfaces.
• Do not switch on the hot plates unless covered with
a cooking utensil.
•
Do not allow liquids to boil over: On boiling, reduce
the heat.
•
Do not use the hob as a work surface or a support.
•
Do not leave the hob unattended when frying as this
can increase the risk of fire.
ENERGY SAVING TIPS
•
Use flat bottomed pots and pans whose base is the
same size as or slightly larger than that of the
hotplate.
•
If possible, keep pots covered when cooking.
•
Cook vegetables, potatoes, etc. with little water in
order to reduce the cooking time.
•
Using a pressure cooker saves further cooking time
and reduces energy consumption.
CARE AND CLEANING
•
Always disconnect the cooking hob from the mains
before cleaning and maintenance.
•
Clean enamelled and/or stainless steel parts with a
suitable cleaning product.
•
Do not use abrasive or corrosive materials. Do not use
chlorine based cleaning products.
•
Do not leave acid or alkaline substances, such as
vinegar, salt or lemon juice, etc., on the work
surfaces.
•
Clean the hot plates with a damp cloth and
occasionally rub cooking oil well into them with a soft
cloth.
TROUBLESHOOTING GUIDE
The cooking hob does not work.
Check that:
•
The switch is in the ON position.
•
Check for a power failure.
6en66008.fm Page 12 Tuesday, March 18, 2003 9:44 AM
13
AFTER SALES SERVICE
Before contacting After Sales Service
1.
Try to resolve the problem
(see “Troubleshooting Guide”).
2.
Turn the appliance off then on again and see if the
fault recurs.
If the problem has not been resolved contact
your nearest After Sales Service Dept.
Please give
:
• A brief description of the fault.
• The exact appliance type and model,
• the service number (number after the word
SERVICE on the rating plate) is located on the
underside of the cooking hob. The service number
is also given in the guarantee booklet,
• your complete address and phone number.
If any repairs are required, please contact
an authorised
After Sales Service Dept.
as indicated in the warranty.
In the unlikely event that an operation or repair is carried
out by an
unauthorised technician
, always request a
certification of the job carried out and insist on the use
of
original spare parts
.
Failure to comply with these instructions may
compromise the safety and quality of the product
.
6en66008.fm Page 13 Tuesday, March 18, 2003 9:44 AM
-
1
-
2
-
3
-
4
-
5
IKEA HOB 051 S User guide
- Category
- Hobs
- Type
- User guide
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
LADEN PRS 300/NE User guide
-
Whirlpool AKR 021/IX User guide
-
Whirlpool AKZ 312/01 IX Owner's manual
-
Whirlpool AKM 992/IX User guide
-
-
Ignis PGV 200/NB/01 User guide
-
Bauknecht EKI 6640/IN Installation guide
-
Whirlpool AKT 860/BA User guide
-
-
Whirlpool MKV 1118 User guide